A.show session
B.show cdp neighbors
C.show users
D.show queue

A.It is used to validate the sources of VTP advertisements sent between switches.
B.It is used to access the VTP server to make changes to the VTP configuration.
C.It allows two VTP servers to exist in the same domain, each configured with different passwords.
D.It is the password required when promoting a switch from VTP client mode to VTP server mode.
E.It is used to prevent a switch newly added to the network from sending incorrect VLAN information to the other switches in the domain.

A.to provide routing to a local web server
B.to provide routing from an ISP to a stub network
C.to provide routing that will override the configured dynamic routing protocol
D.to provide routing to a destination that is not specified in the routing table and which is outside the local network

A.to verify the type of cable interconnecting two devices
B.to determine the status of network services on a remote device
C.to obtain VLAN information from directly connected switches
D.to verify Layer 2 connectivity between two devices when Layer 3 fails
E.to obtain the IP address of a connected device in order to telnet to the device
F.to determine the status of the routing protocols between directly connected routers

A.Passive routes are in the process of being calculated by DUAL.
B.EIGRP supports VLSM, route summarization, and routing update authentication.
C.EIGRP exchanges full routing table information with neighboring routers with every update.
D.If the feasible successor has a higher advertised distance than the successor route, it becomes the primary route.
E.A query process is used to discover a replacement for a failed route if a feasible successor is not identified from the current routing information.

A.Broadcasts only use network layer addressing.
B.A broadcast frame is never forwarded by a switch.
C.A broadcast address will never be the source address of a frame.
D.Broadcast addresses use an incorrect format for the switching table.
E.Broadcast frames are never sent to switches.

A.transport type all
B.transport output all
C.transport preferred all
D.transport input all

A.The data is moving from 10BASE-TX to 100BASE-TX.
B.The WAN encapsulation type has changed.
C.The data format has changed from analog to digital.
D.The source and destination hosts are in the same subnet.
E.The source and destination MAC addresses have changed.

A.Set the SSID value in the client software to public.
B.Configure open authentication on the AP and the client.
C.Set the SSID value on the client to the SSID configured on the AP.
D.Configure MAC address filtering to permit the client to connect to the AP.

A.application layer
B.session layer
C.transport layer
D.network layer
E.datalink layer
F.physical layer