多項選擇題Which commands are required to properly configure a router to properly configure a router to run OSPFand to add network 192.168.16.0/24 to OSPF area 0?()

A.Router(config)#router ospf 1
B.Router(config)#router ospf 0
C.Router(config)#router ospf  area 0
D.Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E.Router(config-router)#network 192.168.16.0 0.0.0.255 0
F.Router(config-router)#network 192.168.16.0 255.255.255.0 area 0


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題How many addresses for hosts will the network 124.12.4.0/22 provide?()

A.510
B.1022
C.1024
D.2048

2.單項選擇題Which statement about vlan operation on cisco catalyst switches is true?()

A.when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table
B.unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C.ports between switches should be configured in access mode so that vlans can span across the ports
D.broadcast and multicast frames are retransmitted to ports that are configured on different vlan

3.單項選擇題For the network 192.0.2.0/23, which option is a valid IP address that can be assigned to a host?()

A.192.0.2.0
B.192.0.2.255
C.192.0.3.255
D.192.0.4.0

5.單項選擇題

Refer to the exhibit.Which statement describes DLCI 17?()

 

A.DLCI 17 describes the ISDN circuit between R2 and R3.
B.DLCI17 describes a PVC on R2.It cannot be used on R3 or R1.
C.DLCI17 is the Layer 2 address used by R2 to describe a PVC to R3.
D.DLCI17 describes the dial-up circuit from R2 and R3 to the service provider.

6.單項選擇題Which command shows your active Telnet connections?()

A.show session
B.show cdp neighbors
C.show users
D.show queue

7.多項選擇題Which two statements describe the advantages to the use of RIP over the use of OSPF?()

A.RIP requires less time to converge
B.RIP uses less bandwidth
C.RIP is less complex to configure
D.RIP demands fewer router resources
E.RIP has a more accurate metric

8.單項選擇題Which commands is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?()

A.transport type all
B.transport output all
C.transport preferred all
D.transport input all

9.單項選擇題On the network 131.1.123.0/27, what is the last IP address that can be assigned to a host?()

A.131.1.123.30
B.131.1.123.31
C.131.1.123.32
D.131.1.123.33

10.單項選擇題What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table()。

A.The switch will not forward unicast frames.
B.The switch will forward the frame to a specific port.
C.The switch will return a copy of the frame out the source port.
D.The switch will remove the destination MAC from the switch table.
E.The switch will forward the frame to all ports except the port on which it was received.

最新試題

OSI 哪一層可提供有序的數據重構服務?()

題型:單項選擇題

在Cisco IOS 設備中,啟動配置文件存儲于何處?()

題型:單項選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:單項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€(gè)廣播域?()

題型:單項選擇題

請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()

題型:多項選擇題

在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()

題型:單項選擇題

請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet??梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址?()

題型:單項選擇題

請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()

題型:單項選擇題

請參見圖示。哪種邏輯拓?fù)涫菍D示網絡的準確描述?()

題型:單項選擇題

OSI 模型的哪兩項功能在第2層實現?()

題型:多項選擇題