A.Switch1(config-if)# switchport port-security maximum 1
B.Switch1(config)# mac-address-table secure
C.Switch1(config)# access-list 10 permit ip host
D.Switch1(config-if)# switchport port-security violation shutdown
E.Switch1(config-if)# ip access-group 10
您可能感興趣的試卷
你可能感興趣的試題
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.Switch1 - Fa 0/2
B.Switch1 - Fa 0/9
C.Switch2 - Fa 0/3
D.Switch2 - Fa 0/4
E.Switch2 - Fa 0/8
F.Router - Fa 1/0
A.If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.
B.If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
C.If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.
D.If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
E.If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.
F.If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.
A.addresses chosen by a company to communicate with the Internet
B.addresses that cannot be routed through the public Internet
C.addresses that can be routed through the public Internet
D.a scheme to conserve public addresses
E.addresses licensed to enterprises or ISPs by an Internet registry organization
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic
C.Configure many sub-interfaces on the same subnet
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces
Which routing protocols will support the following IP addressing scheme? ()
Network 1 - 192.168.10.0 /26
Network 2 - 192.168.10.64 /27
Network 3 - 192.168.10.96 /27
Network 4 - 192.168.10.128 /30
Network 5 - 192.168.10.132 /30
A.RIP version 1
B.RIP version 2
C.IGRP
D.EIGRP
E.OSPF
A.Layer2
B.Layer3
C.Layer4
D.Layer5
E.Layer6
F.Layer7
A.By default, all defined VLANs are allowed on the trunk.
B.Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C.Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D.Each single VLAN, or VLAN range, must be specified with the vlan database command.
最新試題
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
在路由器上使用Router#copy running-config startup-config 命令會產生什么效果?()
請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中存在多少個廣播域?()
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()
請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()
請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet??梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址?()
路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()