A.reflexive
B.extended
C.standard
D.dynamic

A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users

A.A hub is connected directly to FastEthernet0/5
B.FastEthernet0/1 is configured as a trunk link.
C.FastEthernet0/5 has statically assigned mac address
D.Interface FastEthernet0/2 has been disable.
E.Multiple devices are connected directly to FastEthernet0/1.
F.FastEthernet0/1 is connected to a host with multiple network interface cards.

A.24
B.4
C.8
D.16

A.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1
B.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1
C.switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1
D.switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1

A.The IP address for Server A is a broadcast address.
B.The IP address for Workstation B is a subnet address.
C.The gateway for Workstation B is not on the same subnet.
D.The gateway for Server A is not on the same subnet.

A.The switchport belongs only to VLAN 2
B.Interface fa0/0 will be in both VLAN 1 (by default) and VLAN 2
C.The exhibit shows interface fa0/0 to be dynamically mapped to VLAN 2
D.A network host can be connected to this interface

A. A remote physical layer problem exists.
B. The host NIC is not functioning.
C. TCP/IP has not been correctly installed on the host.
D. A local physical layer problem exists.

A.switch to switch
B.switch to hub
C.switch to router
D.hub to hub
E.router to PC

A.The transport layer divides a data stream into segments and may add reliability and flow control information.
B.The data link layer adds physical source and destination addresses and an FCS to the segment.
C.Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D.Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E.The presentation layer translates bits into voltages for transmission across the physical link.