A.no VLANs
B.all VLANs
C.only VLANs 1 - 64
D.only the VLANs that are specified when creating the trunk
您可能感興趣的試卷
你可能感興趣的試題
A.It creates a VLAN 999 interface.
B.It designates VLAN 999 for untagged traffic.
C.It blocks VLAN 999 traffic from passing on the trunk.
D.It designates VLAN 999 as the default for all unknown tagged traffic.
A.It checks the configuration register.
B.It attempts to boot from a TFTP server.
C.It loads the first image file in flash memory.
D.It inspects the configuration file in NVRAM for boot instructions.
A.packet switching
B.access layer security
C.path selection
D.VLAN membership assignment
E.bridging between LAN segments
F.microsegmentation of broadcast domains
A.session
B.transport
C.network
D.data link
E.physical
A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address
A.BSS
B.ESS
C.IBSS
D.SSID
A.Because of damaged flash memory， the router will fail the POST
B.It will attempt to locate the IOS from a TFTP server. If this fails， it will initiate the setup dialog.
C.It will attempt to locate the IOS from a TFTP server. If this fails， it will load a limited IOS from ROM
D.It will attempt to locate the configuration file from a TFTP server. If this fails， it will initiate the setup dialog.
E.It will attempt to locate the configuration file from a TFTP server. If this fails， it will load a limited configuration from ROM
A.the summarized address for all of the internal subnetted addresses
B.the MAC address of the router used by inside hosts to connect to the Internet
C.a globally unique， private IP address assigned to a host on the inside network
D.a registered address that represents an inside host to an outside network
A.VTP allows routing between VLANs.
B.VTP allows a single port to carry information to more than one VLAN
C.VTP allows physically redundant links while preventing switching loops.
D.VTP allows switches to share VLAN configuration information.
A.point-to-point and multiaccess
B.point-to-multipoint and multiaccess
C.point-to-point and point-to-multipoint
D.nonbroadcast and broadcast multipoint
E.nonbroadcast and broadcast multiaccess
最新試題
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）
Which statement is true, as relates to classful or classless routing?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
At which layer of the OSI model dose PPP perform?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
On which options are standard access list based?（）