Refer to the exhibit.A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected， the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA， and then observes the output from these two show commands. Which two of these changes are necessary for SwitchA to meet the requirements？（）
A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.
您可能感興趣的試卷
你可能感興趣的試題
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
A.802.1Q native VLAN frames are untagged by default.
B.802.1Q trunking ports can also be secure ports.
C.802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.802.1Q trunks require full-duplex， point-to-point connectivity.
E.802.1Q trunks should have native VLANs that are the same at both ends.
A.172.31.17.4/30
B.172.31.51.16/30
C.172.31.64.0/18
D.172.31.80.0/22
E.172.31.92.0/22
F.172.31.192.0/18
A.在二層唯一確定一臺設備
B.是設備在不同的網絡中通信
C.區別二層和三層幀
D.確定設備的優先級
E.是同一網絡的不同設備可以通信
F.當不知道遠程設備的物理地址時可以查詢
A.RSTP cannot operate with PVST+.
B.RSTP defines new port roles.
C.RSTP defines no new port states.
D.RSTP is a proprietary implementation of IEEE 802.1D STP.
E.RSTP is compatible with the original IEEE 802.1D STP.
A.It checks the configuration register
B.It attempts to boot from a TFTP server
C.It loads the first image file in flash memory
D.It inspects the configuration file in NVRAM for boot instructions
A.ipv6 host
B.ipv6 unicast-routing
C.ipv6 local
D.ipv6 neighbor
A.Executing password recovery is required.
B.The virtual terminal lines are misconfigured.
C.Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D.Power cycle of NewSwitch will return it to a default configuration.
Refer to the exhibit.This command is executed on 2960Switch：
2960Switch（config）# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command？（）
A.Port security is implemented on the fa0/1 interface.
B.MAC address 0000.00aa.aaaa does not need to be learned by this switch.
C.Only MAC address 0000.00aa.aaaa can source frames on the fa0/1 segment.
D.Frames with a Layer 2 source address of 0000.00aa.aaaa will be forwarded out fa0/1.
E.MAC address 0000.00aa.aaaa will be listed in the MAC address table for interface fa0/1 only.
A.255.255.255.240
B.255.255.255.254
C.255.255.255.252
D.255.255.255.0
E.255.255.255.248
最新試題
請參見圖示。當計算機A 向計算機D 發送幀時，哪些計算機會接收該幀？（）
請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間，路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時，它的源MAC 地址是什么？（）
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口？（）
請參見圖示。下列哪組設備僅包含中間設備？（）
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet?？梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址？（）
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述，哪兩項是正確的？（）
請參見圖示。在網絡中，PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序？（）
請參見圖示。一臺路由器（其路由表如圖所示）收到發往192.168.1.4的數據包。路由器將如何處理該數據包？（）
何時必須使用clock rate 命令配置路由器串行接口？（）
在路由器上使用Router#copy running-config startup-config 命令會產生什么效果？（）