Refer to the exhibit. In this network， R1 is configured not to perform autosummarization within EIGRP. What routes will R3 learn from R2 through EIGRP？（）
A.172.30.1.0/24 and 10.1.2.0/24； EIGRP only performs autosummarization at the edge between two major networks.
B.172.30.0.0/16 and 10.1.2.0/24； R2 will perform autosummarization， although R1 will not.
C.Since R2 is configured without autosummarization， it will not propagate the 172.30.1.0/24 route.
D.172.30.0.0/8 and 10.0.0.0/8.
您可能感興趣的試卷
你可能感興趣的試題
A.loop guard
B.storm control
C.storm suppression
D.broadcast suppression
E.BPDU guard
A.The IOS default is for a last-hop router to trigger a switch to the shortest path tree as soon as a new source is detected on the shared tree.
B.The IOS default is for every one of the routers on the shared tree to trigger a switch to the shortest path tree as soon as a new source is detected on the shared tree.
C.The default behavior of switching to the shortest path tree as soon as a new source is detected on the shared tree can be disabled by setting the value in the ip pim spt-threshold command to "infinity."
D.The default behavior of switching to the shortest path tree as soon as a new source is detected on the shared tree can be disabled by setting the value in the ip pim spt-threshold command to "zero."
Refer to the exhibit. In this network， R1 has been configured to advertise a summary route， 192.168.0.0/22， to R2. R2 has been configured to advertise a summary route， 192.168.0.0/21， to R1. Both routers have been configured to remove the discard route （the route to null created when a summary route is configured） by setting the administrative distance of the discard route to 255.What will happen if R1 receives a packet destined to 192.168.3.1？（）
A.The packet will loop between R1 and R2.
B.It is not possible to set the administrative distance on a summary to 255.
C.The packet will be forwarded to R2， where it will be routed to null0.
D.The packet will be dropped by R1， since there is no route to 192.168.3.1.
A.Multicast Source Discovery Protocol mesh-groups must be configured between the two anycast RPs.
B.The RPs must be within the same IGP domain.
C.Multicast Source Discovery Protocol must be configured between the two anycast RPs.
D.The two anycast RPs must be IBGP peers.
A.enable a Cisco router to "passively" listen to Auto-RP packets without the router actively sending or forwarding any of the packets
B.allow Auto-RP packets in groups 224.0.1.39 and 224.0.1.40 to be flooded in dense mode out interfaces configured with the ip pim sparse-mode command
C.enable the use of Auto-RP on a router
D.configure the router as an Auto-RP mapping agent
A.PIM join messages are sent every 60 seconds to refresh the upstream router’s mroute state for the multicast tree.
B.Routers send a PIM join acknowledgement in response to each PIM join message received from a downstream router.
C.PIM join messages are only sent when the multicast distribution tree is first being established.
D.PIM join messages are sent every three minutes to refresh the upstream router’s mroute state for the multicast tree.
最新試題
what is the disadvantage of policing？
問一個怎么樣的屬性，能讓路由不通告給任何的peer？
兩ebgp鄰居發路由過來 ，哪些屬性重置？
hsrp speak狀態是什么意思？
How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?（）
Local Preference？
如何實現擁塞避免？
R1 will choose which path to reach 10.1.0.0？
Which of the following describes the roles of devices in a WAN?（）
What is the next state of initial in spanning-tree protocol？