您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. The Layer 2 network uses VTP to manage its VLAN database. A network designer created all VLANs on the VTP server (switch 1) and it has been advertised through VTP to all other VTP clients (switches 2 through 4). Due to network growth,a network operator decided to add a new switch between switch 1 and switch 3. The network operator has been instructed to use a refurbished switch and use a VTP client. Which three of these factors should the network operator consider to minimize the impact of adding a new switch?()
A.Pay special attention to the VTP revision number, because the higher value takes the priority.
B.Configure all VLANs manually on the new switch in order to avoid connectivity issues.
C.A trunk should be established between the new switch and switches 1 and 3 as VTP only runs over trunk links.
D.Set at least the VTP domain name and password to get the new switch synchronized.
E.An ISL trunk should be established between the new switch and switches 1 and 3,because VTP only runs over ISL.
F.Pay special attention to the VTP revision number, because the lower value takes the priority.
A.hostname
B.loopback address
C.default gateway
D.domain name
E.SSH peer address
A.the number of packets that are discarded because they exceed the maximum packet size of the medium
B.errors created when the CRC generated by the originating LAN station or far-end device does not match the checksum calculated from the data received.
C.the number of packets that are discarded because they are smaller than the minimum packet size of the medium
D.the number of received packets that were ignored by the interface because the interface hardware ran low on internal buffers
E.the number of times that the interface requested another interface within the router to slow down
A.ip http client secure-ciphersuite 3des-ede-cbc-sha
B.ip https max-connections 10
C.ip http timeout-policy idle 30 life 120 requests 100
D.ip http client secure-trustpoint trustpoint-name
A.ip http client secure-ciphersuite 3des-ede-cbc-sha
B.ip https max-connections 10
C.ip http timeout-policy idle 30 life 120 requests 100
D.ip http client secure-trustpoint trustpoint-name
A.Only the FTP PUT operation type is supported.
B.Active mode is supported.
C.Passive FTP transfer modes are supported.
D.FTP URL specified for the FTP GET operation is not supported.
Refer to the exhibit. Look at the command output. What can you use to prevent this behavior?()
A.UDLD
B.spanning-tree loopguard
C.VTP mode transparent
D.switchport mode desirable
最新試題
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?()
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?()
什么是NAT?
A default Frame Relay WAN is classified as what type of physical network?()
what is the advantage of policing opposite to shaping?
What is the three main step of using the QoS feature with MQC command line interface?
兩ebgp鄰居發路由過來 ,哪些屬性重置?
What is the next state of initial in spanning-tree protocol?
一堆交換機一個server、一個transpare,問配置prune在哪里配置?
當將多個交換機加入到MST region當中會發生什么(what happen)?