A. A lightweight AP receives control and configuration from a WLAN controller to which it is associated.
B. A WLAN client that is operating in half-duplex mode will delay all clients in that WLAN
C. A dhoc mode allows mobile clients to connect directly without an intermediate AP
D. Another term for infrastructure mode is independent service set （IBSS）
E. The Aironet 1230 access point is an example of an access point that operates solely as a lightweight access point.
F. WLANs are designed to share the medium and can easily handle an increased demand of channel contention.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. What is the effect on the trust boundary of configuring the command mls qos trust cos on the switch port that is connected to the IP phone？（）
A. Effectively the trust boundary has been moved to the IP phone.
B. The host is now establishing the CoS value and has effectively become the trust boundary.
C. The switch is rewriting packets it receives from the IP phone and determining the CoS value.
D. The switch will no longer tag incoming voice packets and will trust the distribution layer switch to set theCoS
E. RTP will be used to negotiate a CoS value based upon bandwidth utilization on the link.
Refer to the exhibit. Which statement is true about a voice VLAN？（）
A. Physically the voice network and the data network are separate.
B. The voice traffic will normally be on a different IP subnet than will the data traffic.
C. End user intervention is necessary to place the phone into the proper VLAN.
D. The same security policy should be implemented for both voice and data traffic.
E. The data VLAN must be configured as the native VLAN.
A. Dense mode multicast requires explicit join messages from their members.
B. Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted traffic.
C. Sparse mode multicast uses a pull model to send multicast traffic to where it is requested.
D. Sparse mode uses reverse path forwarding （RPF） to prune off redundant flows.
E. The primary use of sparse mode multicast is for test labs and router performance testing.
A. If a packet is sent to a multicast group address， all members of the multicast group will receive it
B. If a packet is sent to a multicast group address， the multicast frame contains the source multicast address
C. A router does not have to be a member of a multicast group to receive multicast data.
D. A router does not have to be a member of a multicast group to send to the group.
E. A router must be a member of a multicast group to receive multicast data.
F. A router must be a member of a multicast group to send to the group.
A. Multicast addresses 224.0.1.0 through 238.255.255.255 are called globally scoped addresses. They are used to multicast data between organizations and across the Internet
B. The multicast address 224.0.0.1 is a globally scoped address that has been reserved for the Network Time Protocol （NTP） by the IANA
C. Multicast addresses 239.0.0.0 through 239.255.255.255 are called limited scope addresses. They are constrained to a local group or organization
D. Multicast addresses 224.0.0.5 and 224.0.0.6 are limited scoped addresses that have been reserved for OSPF
E. Multicast addresses 224.0.0.0 through 224.0.0.255 are used for network protocols on local LAN segments. Because they are always transmitted with a Time to Live （TTL） of 1， they are never forwarded by a router
A.Multicast addresses 224.0.0.0 through 224.0.0.255 are always forwarded because they are transmitted with Time to Live （TTL） greater than 1.
B.Multicast addresses 224.0.0.5 and 224.0.0.6 are source multicast addresses for OSPF routers.
C.Multicast addresses 224.0.0.13 and 224.0.0.22 are reserved link-local addresses used by PIMv2 and IGMPv3.
D.Because they would map to overlapping IP multicast MAC addresses， multicast addresses 224.0.1.1 and 238.1.1.1 could not be used together.
E.Multicast address 224.0.1.1 has been reserved for the Network Time Protocol （NTP） by the IANA
F.The administratively scoped multicast addresses 239.0.0.0 through 239.255.255.255 are similar in purpose to RFC 1918 private unicast addresses.
Refer to the exhibit. Which two statements are correct？ （Choose two.）（）
A. All six routes will be installed in the routing table.
B. Two routes will be installed in the routing table.
C. Four routes will be installed in the routing table.
D. All the routes were redistributed into BGP from an IGP.
E. All the routes were originated by BGP with the network command.
Refer to the exhibit. Which two statements are true about the partial configuration that is provided. （Choose two.） （）
A. All the configured neighbors are in autonomous system 100.
B. The peer group shortens the IBGP configuration.
C. The peer group shortens the EBGP configuration.
D. Only the outgoing filters are applied to BGP updates.
E. Three AS-path filters are applied to each BGP neighbor.
A. No virtual links are allowed.
B. The area cannot be a backbone area.
C. Redistribution is not allowed unless the packet is changed to a type 7 packet.
D. The area has no more than 10 routers.
E. No autonomous system border routers are allowed.
F. Interarea routes are suppressed.
A. 0
B. 1
C. 10
D. 20
最新試題
Refer to the exhibit. Which Virtual Router Redundancy Protocol （VRRP） statement is true about the roles of the master virtual router and the backup virtual router？（）
Refer to the exhibit. Which statement is true about the 6.6.6.0/24 prefix？（）
Which two statements are true about network voice traffic？ （Choose two.）（）
Which two statements are true about voice packets in a LAN？ （Choose two.） （）
Which two types of activities does the Lightweight Access Point Protocol （LWAPP） define？ （Choose two.）（）
Refer to the exhibit. Which three statements accurately describe the result of applying the exhibited route map？（）
What are the two reasons for the appearance of 0.0.0.0 as the next hop for a network in the show ip bgp command output？（）
Which two statements about voice VLANs are correct？（）
Refer to the exhibit. The command spanning-tree guard root is configured on interface Gi0/0 on both switch S2 and S5. The global configuration command spanning-tree uplinkfast has been configured on both switch S2 and S5. The link between switch S4 and S5 fails. Will Host A be able to reach Host B？（）
Which two Aironet enterprise solution statements are true？（）