Refer to the exhibit. What is the most appropriate summarization for these routes?()
A.10.0.0.0/21
B.10.0.0.0/22
C.10.0.0.0/23
D.10.0.0.0/24
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?()
A.255.255.255.0
B.255.255.254.0
C.255.255.252.0
D.255.255.248.0
A. NIC
B. BIA
C. OUI
D. VAI
A.global unicast
B.anycast
C.multicast
D.unspecified address
A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.
A.There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B.A single interface may be assigned multiple IPv6 addresses of any type.
C.Every IPv6 interface contains at least one loopback address.
D.The first 64 bits represent the dynamically created interface ID.
E.Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?()
A.The loopback addresses are on different subnets
B.The value of the dead timers on the router are different
C.Route summarization is enabled on both routers
D.The process indentifier on router A is different than the process identifier on router B
A.There is a mismatch in encapsulation types
B.The wrong type of cable is connected to the interface
C.The interface has been configured with the shutdown command
D.The interface is not receiving any keepalives
E.The interface needs to be configured as a DTE device
F.There is no encapsulation type configured
A.It tells the router or switch to try establish an SSH connection first and if that fail to use telnet.
B.It configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports.
C.It allows seven failed login attempts before the VTY lines are temporarily shutdown.
D.It configures the virtual terminal lines with the password 030752180500.
E.It configures SSH globally for all logins.
A.only passwords configured after the command has been entered will be encrypted
B.Only the enable password will be encrypted
C.Only the enable secret password will be encrypted
D.It will encrypt the secret password and remove the enable secret password from the configuration
E.It will encrypt all current and future passwords.
Refer to the exhibit.The network administrator requires easy configuration options and minimal routing protocol traffic.Which two options provide adequate routing table information for traffic that passes between the two routers and satisfy the requests of the network administrator?()
A.a dynamic routing procotol on InternetRouter to advertise summarized routers to CentralRouter.
B.a dynamic routing procotol on CentralRouter to advertise summarized routers to InternetRouter.
C.a static route on InternetRouter to direct traffic that is destined for 172.16.0.0/16 to CentralRouter.
D.a dynamic routing procotol on InternetRouter to advertise all routes to CentralRouer.
E.a dynamic routing procotol on CentralRouer to advertise all routes to InternetRouter
F.a static,default route on CentralRouter that directs traffic to InternetRouter.
最新試題
Which statement describes the process ID that is used to run OSPF on a router ?()
Which is true about OSPF router-id?()
What authentication type is used by SNMPv2?()
What OSPF command, when configured, will include all interfaces into area 0?()
Which three features are added in SNMPv3 over SNMPv2? ()
In GLBP, which router will respond to client ARP requests?()
Which three statements about Syslog utilization are true?()
What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance?()
What are two benefits of using a single OSPF area network design?()
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? ()