Refer to the exhibit. Both routers have been configured as VoIP gateways. They must also support traditional telephony devices to connect to analog telephones. Which two configuration changes would correctly support the voice requirements?（）
A.On each router， under the dial-peer voice 1 pots configuration， add the port fa0/0 command.
B.On each router， under the dial-peer voice 1 pots configuration， add the port 1/0/0 command.
C.On each router， configure dial-peer voice 1 as a voip connection and configure dial-peer voice 2 as a pots connection.
D.Under the dial-peer voice 1 pots configuration， change the destination pattern of 1111 to 2222 on the R1 router， and 2222 to 1111 on the R2 router.
E.Under the dial-peer voice 2 voip configuration， change the destination pattern of 1111 to 2222 on the R1 router， and 2222 to 1111 on the R2 router.
F.Under the dial-peer voice 2 voip configuration， change the destination target address of 10.2.2.2 to 10.1.1.1 on the R1 router， and the destination target address of 10.1.1.1 to 10.2.2.2 on the R2 router.
您可能感興趣的試卷
你可能感興趣的試題
A.automated alternate routing （AAR）
B.Cisco CallManager Attendant Console
C.real-time protocol （RTP）
D.Survivable Remote Site Telephony （SRST）
A.Use the command ip nbar protocol-discovery to allow identification of stateful protocols. Use the command ip nbar port-map to attach the protocols to an interface.
B.Use the command match protocol rtp to allow identification of real-time audio and video traffic. Use thecommand ip nbar port-map to extend the NBAR functionality for well-known protocols to new port numbers.
C.Use the command match protocol to allow identification of stateful protocols. Use the command ip nbar port-map to attach the protocols to an interface.
D.Configure a traffic class. Configure a traffic policy. Attach the traffic policy to an interface.
E.Configure video streaming. Configure audio streaming. Attach the codec to an interface.
A.5
B.15
C.25
D.35
E.45
F.55
A.Over leased lines，use the multilink ppp command to reduce latency and jitter，and to create Distributed Link Fragmentation and interleaving.
B.Use the service-policy command to attach a traffic flow to an interface on the router.
C.Use the ip rsvp bandwidth command to set a strict upper limit on the bandwidth NBAR uses，and toguarantee admission of any flows.
D.Use the policy-map command to define one or more QoS policies （such as shaping，policing，and so on） to apply to traffic defined by a class map.
E.Use the random-detect dscp command to modify the default minimum and maximum thresholds for the DSCP value.
F.Use the class-map command to define one or more traffic classes by specifying the criteria by which traffic is classified.
A.Implementing DiffServ involves the configuration of RSVP.
B.Implementing IntServ allows QoS to be performed by configuring only the ingress and egress devices.
C.Implementing IntServ involves the utilization of RSVP.
D.Traffic should be classified and marked by the core network devices.
E.Traffic should be classified and marked as close to the edge of the network as possible.
A.CAC provides guaranteed voice quality on a link.
B.CAC artificially limits the number of concurrent voice calls.
C.CAC is used to control the amount of bandwidth that is taken by a call on a link.
D.CAC prevents oversubscription of WAN resources that is caused by too much voice traffic.
E.CAC allows an unlimited number of voice calls while severely restricting，if necessary，other forms of traffic.
F.CAC solves voice congestion problems by using QoS to give priority to UDP traffic.
A.To support fault and policy reporting，the WLSE requires a Wireless Control System （WCS）.
B.When WLSE detects an AP failure，it automatically increases the power and cell coverage of nearbyAPs.
C.WLSE requires the 2700 location appliance to offer location tracking.
D.WLSE can locate rogue APs and automatically shut them down.
E.WLSE configuration is done using the command line interface （CLI） or a WEB based template.
A.A TACACS+ server is required to implement 802.1x.
B.MIC protects against man-in-the-middle and replay attacks.
C.The 802.1x standard provides encryption services for wireless clients.
D.The AES （symmetric block cipher） is specified in the IEEE 802.11i specification.
E.The IEEE 802.11i specification uses RC4 as its encryption mechanism.
F.WPA requires TKIP and AES as encryption methods.
A.AutoQoS is supported on Frame Relay multipoint subinterfaces.
B.AutoQoS is supported on low-speed ATM PVCs in point-to-point subinterfaces.
C.AutoQoS is supported on serial PPP and HDLC interfaces.
D.AutoQoS is supported only on Frame Relay main interfaces and not on any subinterface configuration.
A.Business-critical traffic includes VoIP and voice signaling packets.
B.SDM can be used to configure a basic QoS policy for incoming traffic on WAN interfaces and IPsec tunnels.
C.SDM can provide QoS for real-time traffic and business-critical traffic.
D.SDM creates a custom-queuing （CQ） or a priority-queuing （PQ） policy.
E.SDM creates a low latency queuing （LLQ） service policy with its associated classes.
F.When allocating bandwidth， values can be entered in either bandwidth percentage or kilobytes per second （kBps）.
最新試題
Which of the items stated is typically the most expensive method of improving QoS across WAN links？（）
Which three functions are associated with a Cisco Unified CallManager？ （）
Which statement is true about the Call Admission Control （CAC） feature in VoIP networks？（）
What can be used to maintain the voice quality on a link by limiting the number of calls that can be active at any given time？（）
Which three benefits are realized by implementing Wireless LAN Solution Engine （WLSE）？（）
End-to-end QoS is maintained in the Cisco WLAN deployment model by utilizing what parameter in lieu of 802.1p？（）
In the design of a QoS solution， which two factors should be taken into consideration？（）
In a VoIP network， which type of interface would an analog fax machine connect to？（）
When Cisco SDM is used to generate QoS policy， various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface？ （）
Which three practices are important to the implementation of a DiffServ QoS architecture？（）