A. When properly configured,VTP minimizes VLAN misconfigurations and configuration inconsistencies
B. Each broadcast domain on a switch can have its own unique VTP domain
C. VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured.
D. When properly configured,VTP maintains VLAN configuration consistency and accelerates trunk link negotiation.
E. VTP pruning is used to increase available bandwidth in trunk links
F. Client,server,and transparent are valid VTP modes
G. To configure a switch to be part of two VTP domains,each domain must have its own passwords
您可能感興趣的試卷
你可能感興趣的試題
A. show interfaces interface
B. show vlan bri
C. show interfaces interface switchport
D. show interface interface trunk
E. show interfaces vlan
A. any-to-many communication model
B. delivery of packets to the group interface that is closest to the sending device
C. one-to-many communication model
D. the same address for multiple devices in the group
E. one-to-nearest communication model
F. a unique IPV6 address for each device in the group
A.HMAC-MD5
B.RSA
C.HMAC-SHA-1
D.DH1
E.DH2
A.reduced cost
B.bette rthroughput
C.increased security
D.scalability
E.reduced latency
F.broadband incompatibility
A. EIGRP converges fast RIP because of DUAL and backup routes that are stored in the topology table.
B. EIGRP uses a hello protocol to establish neighbor relationships
C. EIGRP uses split horizon and reverse poisoning to avoid routing loops.
D. EIGRP uses periodic updates to exchange routing information
E. EIGRP allows routers of different manufacturers to interoperate
F. EIGRP supports VLSM and authentication for routing updates.
G. EIGRP use a broadcast address to send routing information.
A. CHAP uses a two-way handshake
B. CHAP authentication periodically occurs after link establishment
C. CHAP has no protection from playback attacks
D. CHAP authentication is performed only upon link establishment
E. CHAP uses a three-way handshake
F. CHAP authentication passwords are sent in plaintext
A. telnet access does not require a password
B. nat
C. no broadcast
D. chanage of destination address in the ipv6 header
E. chanage of source address in the ipv6 header
F. autoconfiguration
A. statically map IPV4 address to IPV6 addresses
B. configuration IPv4 tunnels between IPV6 islands
C. use DHCPv6 to map IPV4 addresses to IPV6 addresses
D. use proxying and translation to translate IPV6 packets into IPV4 packets
E. configure IPV6 directly
F. enable dual-stack routing
A.172.31.17.4/30
B.172.31.51.16/30
C.172.31.64.0/18
D.172.31.80.0/22
E.172.31.92.0/22
F.172.31.192.0/18
A. The number of FECN packets that are received by the router
B. The number of BECN packets that are received by the router
C. The ip address of the local router
D. The value of the local DLCI
E. The status of the PVC that is configured on the router
最新試題
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
At which layer of the OSI model dose PPP perform?（）
What is the default administrative distance of OSPF?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
Which command encrypts all plaintext passwords?（）
At which layer of the OSI model is RSTP used to prevent loops?（）