A.to support fault and policy reporting, the WLSE requires a Wireless Control System (WCS)
B.when WLSE detects an AP failure, it automatically increases the power and cell coverage of nearby APs
C.WLSE requires the 2700 location appliance to offer location tracking
D.WLSE can locate rogue APs and automatically shut them down
E.WLSE configuration is done using the command line interface (CLI) or a WEB based template
您可能感興趣的試卷
你可能感興趣的試題
A.policy routing
B.increase link capacity
C.WRED
D.CBWFQ
E.LFI
F.WFQ
A.TKIP protects RC4 encryption keys
B.CKIP and TKIP protect AES encryption keys
C.TKIP encryption is more processor intensive than AES encryption is
D.WPA requires TKIP encryption, whereas WPA2 supports AES encryption
E.WPA requires AES encryption, whereas WPA2 supports TKIP encryption
A.a set of rules that can be established and associated with the ingress and egress ports of the control plane
B.improves performance of the control plane by marking control plane packets with DSCPEF
C.protects the control plane on a router from DoS attacks
D.treats the control plane as a separate entity with its own ingress (input) and egress (output) ports
E.provides the control plane with a separate token bucket
F.enhances security of the control plane by tunneling packets to and from the control plane
A.both WPA and WPA2 require authentication support via IEEE 802.1 x and Pre-Shared Key (PSK)
B.both WPA and WPA2 address all known Wired Equivalent Privacy (WEP) vulnerabilities in the IEEE 802.11i security implementation
C.WPA is supported on client devices only. WPA2 is supported on both access point (AP) and client devices
D.WPA provides only a standard for authentication. WPA2 provides a standard for authentication and encryption
E.WPA requires encryption support via Temporal Key Integrity Protocol (TKIP) WPA2 provides encryption support via (symmetric block cipher)AES-CCMP
A.WCS
B.WLSE
C.Location Appliance
D.WDS
E.WLSE-Express
A.set a minimum bandwidth guarantee
B.increase bandwidth
C.determine a specific transfer rate
D.establish timers
E.configure CBWFQ for best-effort traffic
F.set a maximum bandwidth limit
A.synchronizes FIFO, PQ, CQ, and MDRR, with WFQ, CBWFQ, and LLQ
B.enables strict priority queuing for voice traffic, and weighted round robin queuing for data traffic
C.enables low latency queuing to ensure that voice traffic receives priority treatment
D.enforces a trust boundary on switch access ports and uplinks/downlinks
E.modifies queue sizes as well as queue weights where required
F.adjusts link speeds to adapt to QoS needs
A.class-based policing is configured using the Modular QoS command-line (MQC)
B.only the Frame Relay traffic-shaping (FRTS) mechanism can interact with a Frame Relay network, adapting to indications of Layer2 congestion in the WAN links
C.Distributed Traffic Shaping (DTS) is configured with the police command under the policy map configuration
D.both Frame Relay traffic shaping (FRTS) and virtual IP (VIP)-based Distributed Traffic Shaping (DTS) have the ability to mark traffic
A.serialization delay
B.end-to-end delay
C.lack of bandwidth
D.inconsistent port costs
E.routing table convergence issues
F.poor file transfer rates
A.video conferencing traffic tends to be much more bursty in nature and is more prone to have an impact on other traffic flows
B.latency requirements are less stringent for video traffic than for voice traffic
C.video traffic is less sensitive to dropped packets than for voice traffic
D.video traffic requires the retransmission capabilities of TCP whereas voice uses UDP
E.video traffic tends to be much more bursty in nature and is more prone to have an impact on other traffic flows
F.voice traffic requires the retransmission capabilities of TCP whereas video uses UDP
最新試題
What are the three models of quality of service (QoS) in a network?()
Which of the items stated is typically the most expensive method of improving QoS across WAN links?()
The Cisco SDM will create a QoS policy that provides services to two types of traffic. Which two statements indicate the default QoS parameters that are created by SDM?()
For delay sensitive traffic, what are the three best ways that are used to prevent packet loss? ()
When QoS levels in the Cisco Wireless Control System (WCS) are entered, which profile names are used to identify the access categories?()
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call? ()
Which set of classes correctly identifies the four traffic classes, from highest priority to lowest priority, specified in the 802.11e standard?()
Within the WMM policy, how many default QoS radio access categories are there?()
What are two reasons to implement H·323 gatekeepers?()
Which two characteristics are common between traffic policing and traffic shaping?()