A.the time required from receipt of the incoming frame， until the frame/packet has been queued for transmission
B.the time taken for a single packet to traverse the physical medium from one end to the other
C.the time taken to place a frame on the physical medium for transport
D.the time spent for a packet to reside in the output queue of a router
您可能感興趣的試卷
你可能感興趣的試題
A.best-effort delivery
B.ingress committed rate （ICR）
C.shaping and policing
D.egress committed rate （ECR）
E.Integrated Services （IntServ）
F.differentiated services （DiffServ）
Refer to the exhibit. The auto discovery qos command was configured on this interface 24 hours prior to the above configuration. Which statement is true about the configuration?（）
A. An IP address is needed on interface seriall/2.
B.The auto discovery qos command should be configured on the subinterface
C.A generated AutoOoS policy has been applied to serial1/2.
D.The collection of data has stopped.
A.LFI
B.LLQ
C.RSVP
D.WFO
E.WRED
A.The PRI field should contain the Cos value of 010
B.The PRI field should contain the Cos value of 011
C.The PRI field should contain the Cos value of 100
D.The PRI field should contain the Cos value of 101
E.The PRI field should contain the Cos value of 110
F.The PRI field should contain the CoS value of 111
A.protection against denial of service （DoS） attacks at infrastructure routers and switches
B. protection against known worm attacks in routers and switches
C.quality of service （QoS） control for packets that are sourced from the data plane of Cisco routers and switches
D.quality of service control （QoS） for packets that are destined to the control plane of Cisco routers and switches
E.quality of service （QoS） control for packets that are destined to the data plane of Cisco routers and switches
A.WLSE supports centralized configuration.
B.WLSE supports distributed configuration.
C.WLSE can pick up statistics on a device even if the device is not properly configured.
D.WLSE can be used to upgrade the firmware on APs and bridges.
E.WLSE monitors device fault and performance conditions but cannot report any policy misconfigurations
A.H323
B.UDP
C.RTP
D.TCP
E.Media Gateway Control Protocol (MGCP)
F.session initiation protocol (SIP)
A.FXS
B.FSO
C.E&M
D.auxiliary port
E.802.3af ethernetports
A.FIFO queuing， which provides a means to hold packets while they are waiting to exit an interface
B.Priority queuing， which ensures a fixed amount of bandwidth
C.Custom queuing （CO）， which provides a queuing tool that services all queues， even during times of congestion
D.Bandwidth queuing， which ensures a minimum amount of bandwidth
E.Weighted fair queuing （WFO）， which classifies packets based on flows
A.World Wide Web traffic using load balanced web servers
B.voice
C.peer to peer applications mission critical applications
D.peer to peer applications
E.multicast routing protocols
最新試題
Which two commands should be entered on a WLAN controller to remove any residual configuration？（）
Which two QoS classification and marking statements are true？ （）
Which two statements are correct about the signaling methods that are utilized for transmitting voice？ （）
What is an advantage of the IntServ QoS model？（）
Which two statements about the Wi-Fi Multimedia （WMM） standard are true？（）
When QoS levels in the Cisco Wireless Control System （WCS） are entered， which profile names are used to identify the access categories？（）
Which option correctly identifies the four main menus of a Cisco Wireless Control System （WCS）？ （）
Which of the items stated is typically the most expensive method of improving QoS across WAN links？（）
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call？ （）
Which Control Plane Policing （CoPP） statement is true？（）