A BGP router is configured as shown below：
interface ethernet 0
ip address 10.10.10.1 255.255.0.0!
int serial 0
ip address 172.16.1.1 255.255.255.252!
router bgp 65001
neighbor 192.168.1.1 remote-as 65002
Based on the above configuration， which of the following BGP statements would inject the10.10.0.0/16 prefix into the BGP routing table？（）
A.network 10.0.0.0
B.network 10.10.0.0 mask 255.255.0.0
C.network 10.10.10.1 mask 255.255.255.255
D.network 10.10.10.0 mask 255.255.255.0
E.network 10.0.0.0 mask 255.255.0.0
您可能感興趣的試卷
你可能感興趣的試題
A.The IBGP routers must always be fully meshed
B.The IBGP routers can be in a different AS
C.The IBGP routers must be directly connected
D.The IBGP routers do not need to be directly connected
E.None of the other alternatives apply are true
The network consists of two separate autonomous systems as shown below：
You need to configure Router R2 as a BGP route reflector and Router R1 as the client. Assumingthat Router R3 isn’t running BGP， which two of the commands below would you enter on R2 tosatisfy your goals？（）
A.neighbor 165.50.12.1 remote-as 65100
B.neighbor 165.50.12.2 remote-as 64000
C.neighbor 165.50.12.1 route-reflector-client
D.neighbor 165.50.12.2 route reflector-client
Refer to the exhibit. All routers are configured for BGP. EBGP routes received on router R2 showup in the BGP table on routers R1 and R3 but not in their IP routing tables. What would causethis？（）
A.EBGP multihop is not configured on routers R1 and R3
B.Routers R1 and R3 do not receive the same routes via an IGP
C.Synchronization in autonomous system 100 is turned is on
D.The BGP routers in autonomous system 100 are not logically fully-meshed
E.Synchronization in autonomous system 100 is turned is off
A.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2
B.The serial 0/0/1 interface on the ISP router has been configured with the set metric 50command
C.The output was generated by entering the show ip bgp command on the SanJose1 router
D.The output was generated by entering the show ip bgp command on the ISP router
E.The serial 0/0/1 interface on the ISP router has been configured with the set metric 75command
F.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
Refer to the exhibit. Router RT3 discovers network 202.176.56.0 via BGP. Which one of thesestatements is true？（）
A.RT1 advertised network 202.176.50.0/24 with a metric of 782
B.RT3 is directly connected to RT1 using subnet 192.168.1.0
C.RT3 has an IGP metric of 782 to reach 192.168.1.1
D.RT3 has a BGP metric of 782 to reach 192.168.1.1
E.RT1 advertised network 202.176.50.0/24 with a metric of 1000
F.RT3 has an IGP metric of 1782 to reach 202.176.56.0/24
A.Memory requirements are higher for shared distribution tree than for source distributiontree.
B.Creates a tree from a central RP to all last-hoprouters.
C.Uses a rendezvous point.
D.An optimal path is created between each source router and each last-hoprouter.
E.Place（S，G）entry in each router’smulticast routing table.
F.Place（*，G）entry in a router’smulticast routing to table.
Refer to the exhibit. Routers RTA and RTB are running BGP but the session is active. Whatcommand needs to be added to establish the BGP session？（）
A.ip route 10.10.10.1 255.255.255.255 s0/0 ip route 10.10.10.1 255.255.255.255 s0/1
B.network 10.10.10.0
C.no synchronization
D.neighbor 10.10.10.1 next-hop-self
A.Statically defined RP
B.Bootstrap Router
C.Auto-RP
D.RP Discovery Protocol（RDP）
E.RP Helios
F.RPARP（RARP）
A.Clear the BGP session
B.Change both the inbound and outbound policy related to this route
C.Use the service-policy command to adjust the QOS policy to allow the route to propagate
D.Use the release BGP routing command
Refer to the exhibit. Router RTR is attempting to establish BGP neighbor relationships with routersRT1 and RT3. On the basis of the information that is presented in the exhibit， which twostatements are true？（）
A.RTR has a BGP password set but neighbor 10.0.0.1 does not
B.Neighbor 10.0.0.5 has a BGP password set but RTR does not
C.RTR has a BGP password set but neighbor 10.0.0.5 does not
D.RTR has a BGP password set but neighbor 10.0.0.1 has an incorrect password set
E.Neighbor 10.0.0.1 has a BGP password set but RTR does not.
F.RTR has a BGP password set but neighbor 10.0.0.5 has an incorrect password set
最新試題
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Drag and drop each management protocol on the above to the correct category on the below.
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
cisco ios command to interface dialer 0
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDK click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDK you can return to yourquestions by clicking on the Questions button to the left.Which IPSec rule is used for the Olympia branch and what does it define？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Which three statements accurately describe IOS Firewall configurations？（）