A. a straight-through cable
B. an EIA/TIA-232 serial cable
C. an auxiliary cable
D. a modem cable
E. a cross-over cable
您可能感興趣的試卷
你可能感興趣的試題
A. Straight-through cable
B. Compatible network interfaces
C. Networking protocol
D. Hub
E. Crossover cable
F. router
A. Rollover cable
B. Console cab le
C. Crossover cable
D. Straight-through cable
E. Serial cable
A. A broadcast domain with too many hosts.
B. Full duplex operation.
C. Broadcast storms.
D. Multicasting.
E. Network Segmentation.
F. Low bandwidth.
A. A switch.
B. A router.
C. A network adapter card.
D. A hub.
E. A repeater.
The TestKing network Topology is displayed in the exhibit below
A switch has been configured for three different VLANs: VLAN 2, VLAN 3, andVLAN 4. For the purposes of communication between VLANs a router is to beadded. Host from one VLAN should be able to reach the hosts in the other VLANs.
Based on this requirement, what type of connection is acceptable between the routerand switch?（）
A. 10 Mbps Ethernet
B. 56 kbps serial
C. 100 Mbps Ethernet
D. 1,544 Mbps serial
E. 1000 Mbps Ethernet
An administrator is configuring a Catalyst switch with VLAN information that must be automatically distributed to other Catalyst switches in the network.
What conditions must be met in order for the VLANs configured on this switch to be automatically configured on the other switches?（）
A. The switch that will share its VLAN configuration must be in VTP server mode.
B. The switches must be in the same VTP domain.
C. The switch that will share the VLAN information must be configured as the root bridge.
D. The switches must be connected over VLAN trunks.
E. The switches must be configured to use the same STP version.
F. The switches must have VTP pruning activated.
A. By default, all defined VLANs are allowed on the trunk.
B. Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C. Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D. Each single VLAN, or VLAN range, must be specified with the vlan database command.
A. They increase the size of collision domains.
B. They allow logical grouping of users by function.
C. They can enhance network security,
D. The increase the size of broadcast domains while decreasing the number of the broadcast domains.
E. The increase the number of broadcast domains while decreasing the size of the broadcast domains.
F. They simplify switch administration.
A. Switch(vlan)# mode trunk
B. Switch(config)# switchport access mode trunk
C. Switch(config-if)# switchport mode trunk
D. Switch(config-if)# switchport trunk encapsulation dot1q
E. Switch(config)# switchport access mode 1
F. Switch(vlan)# trunk encapsulation dot1q
A. VLANs allow access to network services based on department, not physical location.
B. VLANs utilize packet filtering to enhance network security.
C. VLANs provide a low-latency, high bandwidth internetworking alternative.
D. VLANs provide a method of communication between IP addresses in large networks.
E. VLANs establish segmented broadcast domains in switched networks.
F. VLANs can greatly simplify adding, moving, or changing hosts on the network.
最新試題
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）
TestKing.com has allocated the IP add 199.144.27.0 is its network, to provide flexibility for the LAN design, a subnet mask of 255.255.255.240 has been chosen. Which of the following address can be assigned to LAN on the resulting subnets.（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
What is a global command?（）
Which of the following describe router functions?（）
What is the subnetwork address for a host with IP address 201.100.5.68/28?（）
What feature of a networks switch allows an administrative to create separate broadcast domains?（）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）