A cisco wcs version 4.0 has been installed on a server with a dual pentium 3.0 ghz processor，4 gb ram，and an 80 gb hard drive. a location appliance has been incorporated into the network and is being monitored by the cisco wcs. there are 3000 devices to be tracked but not all of them are being tracked on the cisco wcs.
What can be done to correct the problem？（）
A.add a new location appliance.
B.add a new cisco wcs server dedicated to the location appliance.
C.add 4 gb of ram to the cisco wcs.
D.add a 120 gb hard drive to the cisco wcs.
您可能感興趣的試卷
你可能感興趣的試題
You are troubleshooting a problem with a cisco 7920 wireless ip phone that is causing the phone to drop calls. the problem appears to be a roaming bandwidth issuE. in order to verify what kind of issue it is， you decide to increase the bandwidth reserved for roaming on the wlan controller to the maximum.
What level do you set the bandwidth to？（）
A.25 percent
B.15 percent
C.5 percent
D.35 percent
Using the wlse， you are trying to push out a configuration job to a standalone access point， but the job does not start.
Which of the following would cause this failure？（）
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.pop-up blocker enabled in the browser
D.unsupported version of ios firmware in the access point
A.1000
B.1500
C.2000
D.2500
A.16 feet [4.8 meters]
B.24 feet [7.3 meters]
C.8 feet [2.4 meters]
D.40 feet [12.1 meters]
A.12 percent
B.6 percent
C.18 percent
D.24 percent
A.128
B.32
C.16
D.64
A.50
B.128
C.512
D.1024
You are using adu and are authenticated and associated to an access point. however， you are unable to obtain an ip address.
Which of these has caused this problem？（）
A.invalid ssid
B.invalid wep key
C.invalid encryption type
D.invalid 802.1x authentication type
A.network connections
B.location views
C.access points
D.object definitions
最新試題
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）