HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? （）(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
您可能感興趣的試卷
你可能感興趣的試題
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
A.0000.5E00.010a
B.0000.0c07.ac0a
C.0000.0c07.0110
D.000.0cac.070a
A. Proxy ARP
B. IRDP
C. Dynamic Routing Protocol
D. VRRP
A.Both Gateway Load Balancing Protocoland Hot Stand by Router Protocol
B.Gateway Load Balancing Protocol
C.Virtual Router Redundancy Protocol
D.Hot Stand by Router Protocol
A. Shared single interface
B. IP Address
C. TCP-based hello packets
D. MAC address
A. It provides reliable input for verifying network consistency.
B. It requires a network audit to support some upgrade decisions.
C. It requires a network audit to support any network restructuring.
D. It begins with gathering organizational input that may be inaccurate.
A. cost savings
B. product variety
C. well-tested interoperability
D. regular upgrade process
A. Cisco validated Designs can be implemented quickly without customer input.
B. Cisco is focusing on the PIN architecture as a means to driving integrated networks.
C. The Cisco PIN architecture is a critical mechanism for supporting integrated markets because it can be implemented quickly.
D. The Cisco validated Designs program provides critical mechanisms for supporting integrated markets because the mechanisms can be implemented quickly.
A. It strives to protect access to design documentation.
B. It facilitates customer deployments that are more predictable.
C. It facilitates customer deployments that are less reliable.
D. It incorporates products and technologies into a broad portfolio.
A. It incorporates a narrow range of technologies and products.
B. It facilitates faster and more reliable customer deployments.
C. It extends the value of designs through a sustained development plan.
D. It incorporates products and technologies into enterprise, service provider, and commercial systems.
最新試題
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
You have just reinstalled a VIP 6-80 in a Cisco 7500 Series router. What must you do to bring up the port adapter interfaces?（）
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?（）
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
When a Cisco router is configured for SSH, it acts as an （）?