When configuring vlans on an autonomous access point.
What must be configured on the connected switchport？（）
A.802.1q trunking
B.vtp trunking
C.isl trunking
D.dpt trunking
您可能感興趣的試卷
你可能感興趣的試題
There are 30 managed access points on the wlse. a radio scan is started but fails. Upon
inspection of the device list in the reports tab， you notice a red indicator on the wds access point. upon inspection of the wds access point through its guid， it is discovered that the security keys are not set up between the wds access point and the wlse.
Which of the following is mis configured？（）
A.snmp communities
B.telnet/ssh user/password
C.wlccp credentials
D.http user/password
You are using adu and are authenticated and associated to an access point. you are unable to obtain an ip address.
Which of the following will cause this problem？（）
A.aes encryption enabled
B.tkip enabled
C.third-party wireless supplicant enabled
D.802.1x authentication type enabled
On a series 1010 lightweight access point， the alarm led is flashing red， and all other leds are off.
What is the lightweight access point indicating？（）
A.it has lost contact with controller.
B.its ip address already exists.
C.it requires a code upgrade.
D.it is operating normally.
A.router# show wlccp ap
B.router# show wlccp wds ap
C.router# show wlccp cckm
D.router# show wlccp wds cckm
A.dictionary
B.bit-flip and replay
C.mac spoofing
D.man-in-the-middle
A.https
B.tftp
C.rmi
D.http
E.ftp
A.shut down rogue access points
B.configure access points
C.discover access points
D.inventory access points
Using the wlse,you are trying to push out a configuration job to an access point,but the job does not start.
Which of the following would cause this failure？（）
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.unsupported version of ios firmware in the access point
D.pop-up blocker enabled in the browser
A.75
B.100
C.25
D.50
Client association using eap-cisco wireless （leap） is failing， but eap-peap is functioning on an autonomous access point.
Which of the following needs to be enabled on the access point so eap-cisco wireless （leap） is enabled？（）
A.open authentication plus mac
B.open authentication plus eap
C.shared key
D.network eap
最新試題
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）