Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()
A.A
B.B
C.C
D.D
您可能感興趣的試卷
你可能感興趣的試題
A. enable backbone fast
B. enable uplink fast
C. disable portfast
D. enable portfast
A. Shared
B. Point-to-Point
C. Designated
D. Multiaccess non-broadcast
A. Disables the interfaces to prevent traffic flow
B. Clears all the configurations on the interface
C. Switches the port from access mode to trunk mode
D. Converts the port from physical Layer 2 port to physical Layer 3 port
A.9
B.3
C.12
D.6
A. using DHCP snooping
B. snooping the incoming 802.1Q VLAN tag
C. using CDP
D. snooping the CoS marking on the incoming frames
A. Route reflectors are not passing updates properly.
B. BGP synchronization has been enabled.
C. The next-hop address is unreachable.
D. No loopback interface has been configured on a router.
A. debug ip bgp updates
B. debug ip tcp events
C. debug ip bgp transactions
D. debug ip tcp transactions
A. show ip bgp ipv6
B. show protocols ipv6
C. show ipv6 bgp
D. show bgp ipv6
A.paths
B.accepted-routes
C.advertised-routes
D.routes
最新試題
Refer to the exhibit. Which SSH sessions will the SSH server accept?()
Which description is making sense on the basis of the given information?()
What is the purpose of using VPN hardware acceleration equipment?()
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:()
Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?()
Which keyword is used with the show ip bgp neighbors [keyword] command to display all routes that are received and accepted from a neighbor?()
Refer to the exhibit. Which two of these statements are correct? (Choose two.)()
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?()
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()