A.QoS Element for Wireless Phones
B.IGMP Snooping
C.WMM
D.AVVID Priority Mapping
您可能感興趣的試卷
你可能感興趣的試題
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor， 4 GBRAM， and an 80 GB hard drive. A location appliance has been incorporated into the network and is beingmonitored by the Cisco WCS. There are 3000 devices to be tracked but not all of them are being trackedon the Cisco WCS.
What can be done to correct the problem？（）
A.Add 4 GB of RAM to the Cisco WCS.
B.Add a 120 GB hard drive to the Cisco WCS.
C.Add a new location appliance.
D.Add a new Cisco WCS server dedicated to the location appliance.
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN. The phonerings but， when you answer， the call is dropped.
What may have caused this problem？（）
A.The minimum data rate is not set to 11 Mbps.
B.An address resolution protocol is enabled.
C.Publicly Secure Packet forwarding is enabled.
D.The access point is set to the least congested channel.
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standaloneWLAN.
What may have caused this problem？（）
A.The minimum data rate is not set to 11 Mbps.
B.An address resolution protocol has been disabled.
C.Publicly Secure Packet forwarding is enabled.
D.The access point is set to the least congested channel.
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the
phone to drop calls. The problem appears to be a roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserved for roaming on the WLAN controller to themaximum.
What level do you set the bandwidth to？（）
A.5 percent
B.15 percent
C.25 percent
D.35 percent
You have very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops. You want toincrease the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920phones.
What is the lowest percentage of voice-allocated bandwidth you can select on the WLANcontroller？（）
A.25 percent
B.40 percent
C.55 percent
D.75 percent
A.55 percent
B.56 percent
C.75 percent
D.85 percent
A.6 percent
B.12 percent
C.18 percent
D.24 percent
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones.
Which two general control settings should you select？ （）
A.Aggressive Load Balancing on
B.Aggressive Load Balancing off
C.Multicast on
D.Multicast off
E.AP Fallback on
F.AP Fallback off
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to the wirelessnetwork， but clients using PEAP are failing to log on.
Which situation would result in this type of problem？（）
A.The AAA server is set to accept both MS-CHAP v2 and GTC for PEAP authentication.
B.Clients have been set to validate the server identity.
C.Posture validation has not been enabled.
D.Clients and server are not using certificates.
最新試題
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）