A.在接口FastE thernet0/0應(yīng)用access-group14
B.在access-list14中添加access-list 14 permit any any
C.配置FastE therent0/0接口的IP地址為10.90.201.1
D.為接口FastE thernet0/0添加一個(gè)接口描述

A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address

A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7

A.Authentication needs to be changed to PAP for both routers.
B.Serial IP addresses of routers are not on the same subnet.
C.Username/password is incorrectly configured.
D.Router names are incorrectly configured.

A.There are at least two routers participating in the RIP process.
B.A ping to 192.168.168.2 will be successful.
C.A ping to 10.0.15.2 will be successful.
D.RtrA has three interfaces participating in the RIP process.

A.#vtp domain unset
B.#delete vlan.dat
C.#novtp domain
D.#vtp domain null

A.RIP
B.BGP
C.OSPF
D.EIGRP

A.Administratively shut down the interfaces.
B.Physically secure the interfaces.
C.Configure a virtual terminal password and login process.
D.Enter an access list and apply it to the terminal interfaces using the access-class command.
E.Create an access list and apply it to the terminal interfaces using the access-groupc ommand.

A.application layer
B.session layer
C.transport layer
D.network layer
E.datalink layer
F.physical layer

A.A DHCP client uses a ping to detect address conflicts.
B.A DHCP server uses a gratuitous ARP to detect DHCP clients.
C.A DHCP client uses a gratuitous ARP to detect a DHCP server.
D.If an address conflict is detected, the address is removed from the pool and an administrator must resolve the conflict.
E.If an address conflict is detected, the address removed from the pool for an amount of time configurable by the administrator.
F.If an address conflict is detected, the address is removed from the pool and will not be reused until server is rebooted.