A.There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B.A single interface may be assigned multiple IPv6 addresses of any type.
C.Every IPv6 interface contains at least one loopback address.
D.The first 64 bits represent the dynamically created interface ID.
E.Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.Which two devices can be used to complete the connection between the WAN router atthe customer site and the service provider?()
A.modem
B.Frame Relay switch
C.CSU/DSU
D.WAN switch
E.ISDN TA
A.0
B.1
C.2
D.3
E.4
A.Global addresses start with 2000::/3.
B.Link-local addresses start with FE00:/12.
C.Link-local addresses start with FF00::/10.
D.There is only one loopback address and it is ::1.
E.If a global address is assigned to an interface, then that is the only allowable address for the interface.
A.ip route 0.0.0.0 0.0.0.0 s0/0/0
B.ip route 0.0.0.0 0.0.0.0 209.165.200.226
C.ip route 209.165.200.0 255.255.255.0 192.168.1.250
D.ip route 192.168.1.0 255.255.255.0 209.165.100.250
A.show ip interface [interface] access-lists
B.show ip access-lists interface [interface]
C.show ip interface [interface]
D.show ip access-lists [interface]
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.R1 will forward the packet out all interfaces.
B.R1 will drop this packet because this it is not a valid IP address.
C.As R1 forwards the frame containing this packet, Sw-A will add 192.168.1.255 to its MAC table.
D.R1 will encapsulate the packet in a frame with a destination MAC address of FF-FF-FF-FF-FF-FF
E.As R1 forwards the frame containing this packet, Sw-A will forward it to the device assigned the IP address of 192.168.1.255.
A.Drop the data.
B.Send the data frames to the default gateway.
C.Create an ARP request to get a MAC address for the receiving host.
D.Send a TCP SYN and wait for the SYN ACK with the IP address of the receiving host.
Refer to the exhibit.The Lakside Company has the internetwork in the exhibit.The administrator would liketo reduce the size of routing table on the Central router.Which partial routing table entry in the Central routerepresents a route summary that represents the vlans in Phoenix but no additional subnets?()
A.10.0.0.0/22 is subnetted,1 subnets D 10.4.0.0[90/20514560] via 10.2.0.2,6w0d,serial0/1
B.10.0.0.0/28 is subnetted,1 subnets D 10.2.0.0[90/20514560] via 10.2.0.2,6w0d,serial0/1
C.10.0.0.0/22 is subnetted,1 subnets D 10.0.0.0[90/20514560] via 10.2.0.2,6w0d,serial0/1
D.10.0.0.0/30 is subnetted,1 subnets D 10.2.2.0[90/20514560] via 10.2.0.2,6w0d,serial0/1
E.10.0.0.0/28 is subnetted,1 subnets D 10.4.4.0[90/20514560] via 10.2.0.2,6w0d,serial0/1
F.10.0.0.0/30 is subnetted,1 subnets D 10.4.4.4[90/20514560] via 10.2.0.2,6w0d,serial0/1
A.mismatched TKIP encryption
B.null SSID
C.cordless phones
D.mismatched SSID
E.metal file cabinets
F.antenna type or direction
最新試題
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()
何時必須使用clock rate 命令配置路由器串行接口?()
路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()
請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()
下列哪些是私有IP 地址的地址范圍?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
以下哪兩種介質可提供高達1Gb/s 的帶寬?()