單項選擇題A default Frame Relay WAN is classified as what type of physical network?()

A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint
E.broadcast point-to-multipoint


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.0 0.0.0.255 any What is the effect of this access list configuration?()

A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations

2.多項選擇題Which statements describe the routing protocol OSPF?()

A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.

4.單項選擇題How will the above access lists affect traffic?()

A.FTP traffic from 192.169.1.22 will be denied
B.No traffic, except for FTP traffic will be allowed to exit E0
C.FTP traffic from 192.169.1.9 to any host will be denied
D.All traffic exiting E0 will be denied
E.All FTP traffic to network 192.169.1.9/29 will be denied

5.多項選擇題What information does a router running a link-state protocol use to build and maintain its topological database? ()

A. hello packets
B. SAP messages sent by other routers 
C. LSAs from other routers
D. beacons received on point-to-point links
E. routing tables received from other link-state routers
F. TTL packets from designated routers

6.單項選擇題

Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured,what could be thecause of this problem?()

A.HostA is not on the same subnet as its default gateway
B.The address of SwitchA is a subnet address
C.The Fa0/0 interface on RouterA is on a subnet that cannot be used
D.The serial interfaces of the routers are not on the same subnet
E.The Fa0/0 interface on RouterB is using a broadcast address

8.單項選擇題A network administrator wants to add a line to an access list that will block only Telnet access by the hosts on subnet 192.168.1.128/28 to the server at 192.168.1.5. What command should be issued to accomplish this task?()

A.access-list 101 deny tcp 192.168.1.128 0.0.0.15 192.168.1.5 0.0.0.0 eq 23  access-list 101 permit ip any any
B.access-list 101 deny tcp 192.168.1.128 0.0.0.240 192.168.1.5 0.0.0.0 eq 23  access-list 101 permit ip any any
C.access-list 1 deny tcp 192.168.1.128 0.0.0.255 192.168.1.5 0.0.0.0 eq 21  access-list 1 permit ip any any
D.access-list 1 deny tcp 192.168.1.128 0.0.0.15 host 192.168.1.5 eq 23  access-list 1 permit ip any any


9.單項選擇題Which spread spectrum technology does the 802.11b standard define foroperation?()

A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR,F(xiàn)HSS,and DSSS

最新試題

請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()

題型:多項選擇題

以下哪兩種介質可提供高達1Gb/s 的帶寬?()

題型:多項選擇題

請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()

題型:單項選擇題

請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()

題型:單項選擇題

請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()

題型:多項選擇題

PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()

題型:單項選擇題

請參見圖示。公司路由器由于故障被更換。更換路由器之后,Education 辦公室內的主機C 和D 能夠相互ping 通,但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么?()

題型:單項選擇題

下列哪些是私有IP 地址的地址范圍?()

題型:多項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:單項選擇題

在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()

題型:單項選擇題