多項選擇題What are two advantages of Layer 2 Ethernet switches over hubs?()

A.decreasing the number of collision domains
B.filtering frames based on MAC addresses
C.allowing simultaneous frame transmissions
D.increasing the size of broadcast domains
E.increasing the maximum length of UTP cabling between devices


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題What can be done to secure the virtual terminal interfaces on a router?()

A.Administratively shut down the interface.
B.Physically secure the interface.
C.Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D.Configure a virtual terminal password and login process.
E.Enter an access list and apply it to the virtual terminal interfaces using the access-class command.

3.多項選擇題Which two statements apply to dynamic access lists?()

A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users.

4.多項選擇題Which two of these are characteristics of the 802.1Q protocol?()

A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.

6.多項選擇題Which two data link layers are supported by cisco ios software for IPv6?()

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC

7.單項選擇題

Refer to the exhibit.Give this output for SwitchC, what should the network administrator’s next action be?()

A.Check the trunk encapsulation mode for SwitchC’s fa0/1 port.
B.Check the duplex mode for SwitchC’s fa0/1 port.
C.Check the duplex mode for SwitchA’s fa0/2 port.
D.Check the trunk encapsulation mode for SwitchA’s fa0/2 port.

8.單項選擇題Which PPP subprotocol negotiates authentication options?()

A.NCP
B.LCP
C.ISDN
D.DLCI
E.SLIP

9.多項選擇題

What can be determined from the line of show ip route output shown in the exhibit?()

A. The next routing update can be expected in 35 seconds. 
B. The IP address 10.10.10.6 is configured on S0/1. 
C. The IP address 10.10.10.8 is configured on S0/1.
D. This route is using the default administrative distance. 
E. The 10.10.10.8 network is two hops away from this router.

10.多項選擇題Which three statements accurately describe layer 2 Ethernet switches?()

A.Microsegmentation decreases the number of collisions on the network.
B.if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C.Spanning Tree Protocol allows switches to automatically share vlan information.
D.In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E.Establishing vlans increases the number of broadcast domains.
F.Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.

最新試題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()

題型:多項選擇題

請參見圖示。哪種邏輯拓?fù)涫菍?duì)圖示網絡的準確描述?()

題型:單項選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:單項選擇題

請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()

題型:多項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲行枰嗌賯€(gè)邏輯地址范圍?()

題型:單項選擇題

OSI 模型的哪兩項功能在第2層實現?()

題型:多項選擇題

下列哪些是私有IP 地址的地址范圍?()

題型:多項選擇題

在Cisco IOS 設備中,啟動配置文件存儲于何處?()

題型:單項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:單項選擇題

請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()

題型:單項選擇題