A.Bandwidth,Delay,and MTU
B.Bandwidth
C.Bandwidth and MTU
D.Bandwidth , MTU,Reliability,Delay,and Load

A. forwards the received packet out the Serial0/0 interface
B. forwards a packet containing an EIGRP advertisement out the Serial0/1 interface 
C. forwards a packet containing an ICMP message out the FastEthernet0/0 interface
D. forwards a packet containing an ARP request out the FastEthernet0/1 interface

A.decreasing the number of collision domains
B.filtering frames based on MAC addresses
C.allowing simultaneous frame transmissions
D.increasing the size of broadcast domains
E.increasing the maximum length of UTP cabling between devices

A.reflexive
B.extended
C.standard
D.dynamic

A.Administratively shut down the interface.
B.Physically secure the interface.
C.Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D.Configure a virtual terminal password and login process.
E.Enter an access list and apply it to the virtual terminal interfaces using the access-class command.

A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users.

A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.

A.redundant
B.spanned
C.provisioned
D.converged

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC

A.Check the trunk encapsulation mode for SwitchC’s fa0/1 port.
B.Check the duplex mode for SwitchC’s fa0/1 port.
C.Check the duplex mode for SwitchA’s fa0/2 port.
D.Check the trunk encapsulation mode for SwitchA’s fa0/2 port.