A.Loop guard only operates on interfaces that are considered point-to-point by the spanning tree.
B.Loop guard only operates on root ports.
C.Loop guard only operates on designated ports.
D.Loop guard only operates on edge ports.
您可能感興趣的試卷
你可能感興趣的試題
A.It may allocate IP addresses from an unknown subnet to the users.
B.All multicast traffic can be sniffed by using the DHCP multicast capabilities.
C.The CPU utilization of the first hop router can be overloaded by exploiting DHCP relay open ports.
D.A potential man-in-the-middle attack can be used against the clients.
A. 1) lowest root bridge id,2)lowest sender bridge id,3)lowest port id,4)lowest root path cost
B. 1) lowest root path cost,2)lowest root bridge id,3)lowest sender bridge id,4)lowest sender port id
C. 1) lowest root bridge id,2)lowest sender bridge id,3)lowest root path cost 4)owest sender port id
D. 1) lowest root bridge id,2)lowest root path cost,3)lowest sender bridge id,4)lowest sender port id
A. VTP updates are ignored and forwarded out all ports.
B. VTP updates are ignored and forwarded out trunks only.
C. VTP updates are made to the VLAN database and are forwarded out trunks only.
D. VTP updates are ignored and are not forwarded.
A.Increase the shaping rate for the priority queue.
B.Remove the policer applied on the priority queue.
C.Remove the shaper applied on the priority queue.
D.Increase the policing rate for the priority queue.
A.enforce the placement of the root bridge in the network
B.ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C.enforce the borders of an STP domain
D.ensure that any BPDUs received are forwarded into the STP domain
A.ip pim rp-address
B.ip pim ssm
C.ip pim sparse-mode
D.ip pim passive
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
最新試題
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()
Which three protocols or applications should be placed in a class that is configured with WRED?()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is notconfigured as a route reflector?()
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()
Which of the following is true about the MPLS header and its EXP field size?()
Which three options are valid ways to filter routes from a BGP peer?()
Which three message types are valid PIMv2 message types?()
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one?()