A.ip pim ssm
B.ip pim ssm 232.0.0.0 255.0.0.0
C.ip pim ssm range 50
D.access-list 50 permit 232.0.0.0 15.255.255.255
E.ip pim enable default
您可能感興趣的試卷
你可能感興趣的試題
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
A. 10.1.1.1
B. 10.1.1.2
C. 10.1.1.3
D. The default gateway
A.Source-Active Message
B.PIM Join
C.PIM Hello
D.MSDP Register
A.224.0.1.37
B.224.0.1.38
C.224.0.1.39
D.224.0.1.40
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
A. Take any packet sourced from any address in the 10.2.0.0/16 network or destined to 10.1.14.25 and set the next hop to 10.1.1.1
B. Take any packet sourced from any address in the 10.2.0.0/16 network and destined to 10.1.14.25 and set the next hop to 10.1.1.1
C. Nothing； extended access lists are not allowed in route maps used for policy-based routing
D. Drop any packet sourced from 10.2.0.0/16
A.Register
B.Register-Stop
C.Join/Prune
D.Reject
E.Register-Prune
F.Register-Join
A.router-id 1.2.3.4
B.router-id 2011：：1
C.router-id Loopback0
D.router-id FF02：：5
A.filter-list
B.inbound ACL
C.route-map
D.outbound ACL
E.prefix-list
F.neighbor 10.0.0.1 deny-map my-map command
A.configuring EIGRP stubs
B.configuring a second EIGRP AS and redistributing
C.configuring summary addresses
D.configuring an offset-list
E.configuring a prefix-list
F.configuring unicast neighbors
A.It will fragment the packet at Layer 2.
B.It will fragment the packet at Layer 3.
C.It will drop the packet and send an ICMPv6 message "packet too big" back to the source.
D.It will drop the packet.
A.ldp explicit-null
B.mpls forwarding explicit-null
C.mpls ldp advertise-labels explicit null
D.mpls ldp explicit-null
最新試題
Which three options are valid ways to filter routes from a BGP peer？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which two statements about SA caching are true？（）
Which of the following is true about the MPLS header and its EXP field size？（）
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each，terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs，and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem？（）
Which of these statements about penultimate hop popping are true？（）
Which multicast address is reserved for cisco-rp-discovery？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）