您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Router E learned about the PIM RP （designated as 7.7.7.7） from four different sources. Routers A and D advertised the 7.0.0.0 network via EIGRP. Routers B and C advertised the 7.0.0.0 network via OSPF. Considering that all four Ethernet interfaces on router E could potentially lead back to the PIM-RP， when router E receives the first multicast packet down the shared tree， which incoming interface will be used to successfully pass the RPF check？（）
A.E0
B.E1
C.E2
D.E3
E.None of these interfaces will be used to successfully pass the RPF check
F.All of these interfaces would successfully pass the RPF check
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
A.PG-R3 will receive up to four queries for 192.168.1.0/24， one each from PG-R2， PG-R4， PGR5，and PG-R6.
B.PG-R3 will receive up eight queries for 192.168.1.0/24， one from PG-R2， two from PG-R4，three from PG-R5， and four from PG-R6.
C.PG-R3 will receive one query for 192.168.1.0/24， since the remote routers， PG-R4， PG-R5， and PG-R6， are natural stubs in EIGRP
D.PG-R3 will not receive any queries from PG-R2， because there are no alternate paths for 192.168.1.0/24.
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
A.10.1.1.1
B.10.1.1.2
C.10.1.1.3
D.The default gateway
最新試題
兩ebgp鄰居發路由過來 ，哪些屬性重置？
what is four ospf area type？
QoS機制中的分類，采用ip數據包中的哪個字段？
Local Preference？
SPT初始狀態之后的一個狀態是什么？
當將多個交換機加入到MST region當中會發生什么（what happen）？
Refer to the exhibit.Which statement describes DLCI 17?（）
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?（）
What field in IP packet is used for classification by QOS？