A.Caching allows pacing of MSDP messages.
B.Caching reduces join latency.
C.Caching should not be done by an MSDP speaker.
D.Caching is used to update the BGP MDT address family.
您可能感興趣的試卷
你可能感興趣的試題
A.IGMPv3 has the ability to include or exclude source lists.
B.All IGMPv3 hosts send reports to destination address 224.0.0.22.
C.Only IGMPv2 reports may contain multiple group state records.
D.All IGMPv3 hosts send reports to destination address 224.0.0.23.
E.IGMPv2 does not support the Leave Group message.
A.ip pim ssm
B.ip pim ssm 232.0.0.0 255.0.0.0
C.ip pim ssm range 50
D.access-list 50 permit 232.0.0.0 15.255.255.255
E.ip pim enable default
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
A. 10.1.1.1
B. 10.1.1.2
C. 10.1.1.3
D. The default gateway
A.Source-Active Message
B.PIM Join
C.PIM Hello
D.MSDP Register
A.224.0.1.37
B.224.0.1.38
C.224.0.1.39
D.224.0.1.40
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
A. Take any packet sourced from any address in the 10.2.0.0/16 network or destined to 10.1.14.25 and set the next hop to 10.1.1.1
B. Take any packet sourced from any address in the 10.2.0.0/16 network and destined to 10.1.14.25 and set the next hop to 10.1.1.1
C. Nothing； extended access lists are not allowed in route maps used for policy-based routing
D. Drop any packet sourced from 10.2.0.0/16
A.Register
B.Register-Stop
C.Join/Prune
D.Reject
E.Register-Prune
F.Register-Join
A.router-id 1.2.3.4
B.router-id 2011：：1
C.router-id Loopback0
D.router-id FF02：：5
A.filter-list
B.inbound ACL
C.route-map
D.outbound ACL
E.prefix-list
F.neighbor 10.0.0.1 deny-map my-map command
A.configuring EIGRP stubs
B.configuring a second EIGRP AS and redistributing
C.configuring summary addresses
D.configuring an offset-list
E.configuring a prefix-list
F.configuring unicast neighbors
最新試題
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）
Which three options are valid ways to filter routes from a BGP peer？（）
Which two statements are true about RED？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）