Refer to the exhibit. Two ISPs have decided to use MSDP and configured routers X and Y (both are PIM RPs) as MSDP peers. In the domain of ISP B, PC A has sent an IGMP membership report for the group 224.1.1.1 and PC B has sent an IGMP membership report for the group 224.5.5.5. Assuming that the MSDP peering relationship between routers X and Y is functional, and given the partial configuration output shown from router X, which two of these statements are true?()
A.Router X will contain an entry for 224.1.1.1 in its SA cache and will also have an installed (S,G) entry for this in its mroute table.
B.Router X will not contain an entry for 224.1.1.1 in its SA cache but will have an installed (*,G) entry for this in its mroute table.
C.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed (S,G) entry for this in its mroute table.
D.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed (*,G) entry for this in its mroute table.
E.Router X will have no entries for 224.5.5.5 in neither its SA cache nor in its mroute table.
F.Router X will have no entries for 224.1.1.1 in neither its SA cache nor in its mroute table.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. From the MAC addresses shown in the command output, to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch? ()
A.Fa6/28
B.Fa7/20
C.Gi3/7
D.Fa4/2
E.Fa4/14
F.Fa4/38
A.OSPF external LSAs are automatically flooded into all OSPF areas, unlike type 7 LSAs, which require that redistribution be configured.
B.External LSAs (type 5) are automatically changed to type 1 LSAs at ASBRs.
C.Type 5 LSAs are route summaries describing routes to networks outside the OSPF Autonomous System.
D.External network LSAs (type 5) redistributed from other routing protocols into OSPF are not permitted to flood into a stub area.
A.Each interface has a different OSPF cost.
B.Each interface is configured with secondary addresses as well as primary addresses.
C.Each interface has a different MTU size.
D.Each interface is configured with theip unnumbered loopback 0 command.
Refer to the exhibit. Router E learned about the PIM RP (designated as 7.7.7.7) from four different sources. Routers A and D advertised the 7.0.0.0 network via EIGRP. Routers B and C advertised the 7.0.0.0 network via OSPF. Considering that all four Ethernet interfaces on router E could potentially lead back to the PIM-RP, when router E receives the first multicast packet down the shared tree, which incoming interface will be used to successfully pass the RPF check?()
A.E0
B.E1
C.E2
D.E3
E.None of these interfaces will be used to successfully pass the RPF check
F.All of these interfaces would successfully pass the RPF check
On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()
A.PG-R3 will receive up to four queries for 192.168.1.0/24, one each from PG-R2, PG-R4, PGR5,and PG-R6.
B.PG-R3 will receive up eight queries for 192.168.1.0/24, one from PG-R2, two from PG-R4,three from PG-R5, and four from PG-R6.
C.PG-R3 will receive one query for 192.168.1.0/24, since the remote routers, PG-R4, PG-R5, and PG-R6, are natural stubs in EIGRP
D.PG-R3 will not receive any queries from PG-R2, because there are no alternate paths for 192.168.1.0/24.
最新試題
QoS機制中的分類,采用ip數據包中的哪個字段?
DHCP SERVER在給一個網段設置POOL時,該網段路由器接口地址能不能放入POOL,能why,不能why。
問一個怎么樣的屬性,能讓路由不通告給任何的peer?
What is method list for configure aaa?
如何實現擁塞避免?
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?()
How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?()
As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?()
Local Preference?
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?()