A.A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
B.A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
C.A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
D.A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. What is the most appropriate summarization for these routes?()
A.10.0.0.0/21
B.10.0.0.0/22
C.10.0.0.0/23
D.10.0.0.0/24
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?()
A.255.255.255.0
B.255.255.254.0
C.255.255.252.0
D.255.255.248.0
A. NIC
B. BIA
C. OUI
D. VAI
A.global unicast
B.anycast
C.multicast
D.unspecified address
A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.
A.There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B.A single interface may be assigned multiple IPv6 addresses of any type.
C.Every IPv6 interface contains at least one loopback address.
D.The first 64 bits represent the dynamically created interface ID.
E.Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?()
A.The loopback addresses are on different subnets
B.The value of the dead timers on the router are different
C.Route summarization is enabled on both routers
D.The process indentifier on router A is different than the process identifier on router B
A.There is a mismatch in encapsulation types
B.The wrong type of cable is connected to the interface
C.The interface has been configured with the shutdown command
D.The interface is not receiving any keepalives
E.The interface needs to be configured as a DTE device
F.There is no encapsulation type configured
A.It tells the router or switch to try establish an SSH connection first and if that fail to use telnet.
B.It configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports.
C.It allows seven failed login attempts before the VTY lines are temporarily shutdown.
D.It configures the virtual terminal lines with the password 030752180500.
E.It configures SSH globally for all logins.
A.only passwords configured after the command has been entered will be encrypted
B.Only the enable password will be encrypted
C.Only the enable secret password will be encrypted
D.It will encrypt the secret password and remove the enable secret password from the configuration
E.It will encrypt all current and future passwords.
最新試題
What are three factors a network administrator must consider before implementing Netflow in the network?()
In a GLBP network, who is responsible for the arp request?()
What level will be trapped if the administrator executes the command ?()
Refer to the exhibit.If the devices produced the given output,what is the cause of the EtherChannel problem?()
What are two benefits of using a single OSPF area network design?()
Which three statements about HSRP operation are true?()
What are the Popular destinations for syslog messages to be saved? ()
Which three features are added in SNMPv3 over SNMPv2? ()
What SNMP message alerts the manager to a condition on the network?()
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?()