A. incoming interface.outgoing interface.ip precedence.and differentiated services code P.oint（DSCP）.
B. Incoming interace.ip precedence.differentiated services code point（DSCP），and source or d.estination address.
C. Outgoing interface.ip precedence.differentiated services code point（DSCP）.and source or d.estination address.
D. Incoming interface .outgoing interface.ip precedence and differentiated code point s.ervices（DCPS）
E. Incoming interface .ip precedence .and source or destination address.
F. Outgoing interface.ip precedence .and source or destination address.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit which statement is true？（）
A. telnet traffic originating from the router will be rate limited unless it is destined for hosts 10.1.1.1 or 10.1.1.2
B. the configuration will not rate limit any telnet traffic until it is applied to a router interface.
C. All telnet traffic destined for the router will be rate limited.
D. telnet traffic from hosts 10.1.1.1 and 10.1.1.2 destined for the router will not be rate limited.
After logging into the WCS wireless management server，the administrator is presented with the initial home page showing the network summary.there are four main menu choices across the top horizontal secreen.what is the purpose of the location menu choice？（）
A.to configure the location and addition of a wireless lan controller（WLC） using an ip address.
B.to enable the ：on demand” location of a single rogue AP or rogue client.
C.to configure the communication with a location appliance.
D.to configure the location and addition of a wireless access point using an ip address.
A.weighted RED （WRED） orange or green labels
B.modular QoS CLI （MQC） application layer tags
C.Deficit Round Robin （DRR） precedence bits
D.header compression tags
E.MPLS experimental bits
F.FIFO Layer 2 descriptor labels （L2DL）
A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 2 and Layer 3
E.Layer 3 and Layer 4
A.queue creation
B.determining packet drop thresholds
C.determining the random early detection method
D.traffic classification
E.queue scheduling
F.FIFO configuration
A.both traffic shaping and traffic policing cause retransmissions of connection-oriented protocols such as TCP
B.both traffic shaping and traffic policing support the marking and re-marking of traffic
C.the effects of traffic shaping and traffic policing when configured on a router are applied to outgoing traffic
D.traffic shaping queues excess traffic whereas traffic policing discards excess traffic
E.traffic shaping allows the traffic to exceed the bit rate whereas traffic policing prevents the traffic from exceeding the bit rate
A.prevent packets from being dropped
B.increase available bandwidth
C.reduce hardware errors
D.provide predictable network service
E.eliminate propagation delay
F.eliminate jitter and packet loss
A.use the command ip nbar protocol-discovery to allow identification of stateful protocols. Use the command ip nbar port-map to attach the protocols to an interface
B.use the command match protocol rtp to allow identification of real-time audio and video traffic. Use the command ip nbar port-map to extend the NBAR functionality for well-known protocols to new port numbers
C.use the command match protocol to allow identification of stateful protocols. Use the command ip nbar port-map to attach the protocols to an interface
D.configure a traffic class. Configure a traffic policy. Attach the traffic policy to an interface.
E.configure video streaming. Configure audio streaming. Attach the codec to an interface
A.automated alternate routing （AAR）
B.Cisco CallManager Attendant Console
C.real-time protocol （RTP）
D.Survivable Remote Site Telephony （SRST）
A.to support fault and policy reporting， the WLSE requires a Wireless Control System （WCS）
B.when WLSE detects an AP failure， it automatically increases the power and cell coverage of nearby APs
C.WLSE requires the 2700 location appliance to offer location tracking
D.WLSE can locate rogue APs and automatically shut them down
E.WLSE configuration is done using the command line interface （CLI） or a WEB based template
最新試題
What is an advantage of the IntServ QoS model？（）
Within the WMM policy， how many default QoS radio access categories are there？（）
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call？ （）
What are three Cisco Unified CallManager features？ （）
When deploying a Cisco Wireless Control System （WCS） with the 2700 series location appliance， to within what range is on-demand location of rogue APs possible？（）
Which two statements are correct about the signaling methods that are utilized for transmitting voice？ （）
Which three functions can an Integrated Services Router perform in a VoIP network？（）
When Cisco SDM is used to generate QoS policy， various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface？ （）
Which statement is true about the Call Admission Control （CAC） feature in VoIP networks？（）
The Cisco SDM will create a QoS policy that provides services to two types of traffic. Which two statements indicate the default QoS parameters that are created by SDM？（）