A.The K-values do not match
B.The hold times do not match
C.The hello times do not match
D.The AS numbers do not match
您可能感興趣的試卷
你可能感興趣的試題
A.debug eigrp packets
B.show ip eigrp traffic
C.show ip eigrp topology
D.show ip eigrp neighbors
A.Some query or reply packets are lost between the routers
B.The neighboring router starts receiving route updates from this router
C.A failure causes traffic on a link between two neighboring routers to flow in only one direction（unidirectional link）
D.The neighboring router stops receiving ACK packets from this router
Refer to the exhibit. EIGRP has been configured on routers R1 and R2. However， R1 does notshow R2 as a neighbor and does not accept routing updates from R2. What could be the cause ofthe problem？（）
A.The no auto-summary command has not been issued under the EIGRP process on bothrouters
B.Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24
C.EIGRP cannot exchange routing updates with a neighbor’s router interface that is configuredwith two IP addresses
D.EIGRP cannot form neighbor relationship and exchange routing updates with a secondaryaddress
Based on the above configuration, which of the following BGP statements would inject the 10.10.0.0/16 prefix into the BGP routing table（）
A.network 10.0.0.0
B.network 10.10.0.0 mask 255.255.0.0
C.network 10.10.10.1 mask 255.255.255.255
D.network 10.10.10.0 mask 255.255.255.0
E.network 10.0.0.0 mask 255.255.0.0
Study the exhibit below carefully：
If the configuration shown below is added to Router1， which three route entries will EIGRPadvertise to neighboring routers？（）
router eigrp 10
network 10.0.0.0
eigrp stub
A.192.168.20.0/24
B.10.1.2.0/24
C.10.1.1.0/24
D.10.1.3.0/24
E.10.0.0.0/8
A.The IBGP routers must always be fully meshed.
B.The IBGP routers can be in a different AS.
C.The IBGP routers must be directly connected.
D.TThe IBGP routers do not need to be directly connected.
E.None of the other alternatives apply are true
A network administrator is troubleshooting an EIGRP connection between RouterA， IP address10.1.2.1， and RouterB， IP address 10.1.2.2. Given the debug output on RouterA， which twostatements are true？（）
A.RouterA received a hello packet with mismatched metric-calculation mechanisms
B.RouterA received a hello packet with mismatched authentication parameters
C.RouterA will form an adjacency with RouterB
D.RouterA received a hello packet with mismatched autonomous system numbers
E.RouterA received a hello packet with mismatched hello timers
F.RouterA will not form an adjacency with RouterB
The following command was issued on Router 2：
Given the above output shown above， which statement is true？（）
A.192.168.1.0 is a redistributed route into EIGRP
B.192.168.1.0 is a summarized route
C.192.168.1.0 is a static route
D.192.168.1.0 is equal path load balancing with 172.16.1.0
E.None of the other alternatives apply
The EIGRP network is displayed in the following topology diagram：
You work as a network technician. Study the exhibits carefully. If the command "variance 3" wasadded to the EIGRP configuration of R5， which path or paths would be chosen to route traffic fromR5 to network X？（）
A.R5-R2-R1
B.R5-R2-R1 and R5-R3-R1
C.R5-R3-R1 and R5-R4-R1
D.R5-R2-R1，R5-R3-R1， and R5-R4-R1
A.Use the service-policy command to adjust the QOS policy to allow the route to propagate.
B.Clear the BGP session.
C.Use the release BGP routing command.
D.Change both the inbound and outbound policy related to this route.
E.None of the other alternatives apply
最新試題
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Which statement correctly describes IPsec VPN backup technology？（）
Refer to the exhibit. Which two statements about the AAA configuration are true？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.