A.Spanning Tree Protocol（STP）
B.Delay reduction
C.Hot Standby Routing Protocol（HSRP）
D.Dynamic routing protocols
E.Quality of Service（QoS）
F.Jitter management
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. On the basis of the information presented， which statement is true？（）
A.OSPF router 5.0.0.2 is an ABR
B.Network 6.0.0.0/8 was learned from an OSPF neighbor within the area
C.The default route is learned from an OSPF neighbor
D.A default route is configured on the local router
From the perspective of routerPG-1，what kind of router is the router with IP address 192.23.1.1（）
A.A peer router runningIBGP
B.A peer router runningEBGP
C.A community member running IBGP
D.A peer group member running IBGP
E.A peer group member running EBGP
A.The K-values do not match
B.The hold times do not match
C.The hello times do not match
D.The AS numbers do not match
A.debug eigrp packets
B.show ip eigrp traffic
C.show ip eigrp topology
D.show ip eigrp neighbors
A.Some query or reply packets are lost between the routers
B.The neighboring router starts receiving route updates from this router
C.A failure causes traffic on a link between two neighboring routers to flow in only one direction（unidirectional link）
D.The neighboring router stops receiving ACK packets from this router
Refer to the exhibit. EIGRP has been configured on routers R1 and R2. However， R1 does notshow R2 as a neighbor and does not accept routing updates from R2. What could be the cause ofthe problem？（）
A.The no auto-summary command has not been issued under the EIGRP process on bothrouters
B.Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24
C.EIGRP cannot exchange routing updates with a neighbor’s router interface that is configuredwith two IP addresses
D.EIGRP cannot form neighbor relationship and exchange routing updates with a secondaryaddress
Based on the above configuration, which of the following BGP statements would inject the 10.10.0.0/16 prefix into the BGP routing table（）
A.network 10.0.0.0
B.network 10.10.0.0 mask 255.255.0.0
C.network 10.10.10.1 mask 255.255.255.255
D.network 10.10.10.0 mask 255.255.255.0
E.network 10.0.0.0 mask 255.255.0.0
Study the exhibit below carefully：
If the configuration shown below is added to Router1， which three route entries will EIGRPadvertise to neighboring routers？（）
router eigrp 10
network 10.0.0.0
eigrp stub
A.192.168.20.0/24
B.10.1.2.0/24
C.10.1.1.0/24
D.10.1.3.0/24
E.10.0.0.0/8
A.The IBGP routers must always be fully meshed.
B.The IBGP routers can be in a different AS.
C.The IBGP routers must be directly connected.
D.TThe IBGP routers do not need to be directly connected.
E.None of the other alternatives apply are true
A network administrator is troubleshooting an EIGRP connection between RouterA， IP address10.1.2.1， and RouterB， IP address 10.1.2.2. Given the debug output on RouterA， which twostatements are true？（）
A.RouterA received a hello packet with mismatched metric-calculation mechanisms
B.RouterA received a hello packet with mismatched authentication parameters
C.RouterA will form an adjacency with RouterB
D.RouterA received a hello packet with mismatched autonomous system numbers
E.RouterA received a hello packet with mismatched hello timers
F.RouterA will not form an adjacency with RouterB
最新試題
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
cisco ios command to interface dialer 0
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Match the xDSL type on the above to the most appropriate implementation on the below.