The switched LAN is displayed below：
In this network， STP has been implemented. Switch SW1 is the root switch for the default VLAN.To reduce the broadcast domain， the network administrator decides to split users on the networkinto VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 rootprimary on switch SW1. What will happen as a result of this change？（）
A.Switch SW1 will change its spanning tree priority to become root for VLAN 2 only
B.All ports of the root switch SW1 will remain in forwarding mode throughout the reconvergenceof the spanning tree domain
C.No other switch in the network will be able to become root as long as switch SW1 is up andrunning
D.Switch SW1 will remain root for the default VLAN and will become root for VLAN 2
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
The switched LAN is shown below：
Study the exhibit above carefully. Switch SW5 is configured as the root switch for VLAN 10 but notfor VLAN 20. If the STP configuration is correct， what will be true about Switch SW5？（）
A.All ports in VLAN 10 will be in forwarding mode and all ports in VLAN 20 will be in standbymode
B.All ports will be in forwarding mode
C.All ports in VLAN 10 will be in forwarding mode and all ports in VLAN 20 will be in blockingmode
D.All ports in VLAN 10 will be in forwarding mode
E.None of the other alternatives apply
A.IEEE 802.10
B.Misconfigured NIC
C.User configuration
D.IEEE 802.1Q
E.None of the other alternatives apply
A VTP domain has six active VLANs. Without notice， all VLANs except VLAN1 fail. Just prior tothe failure， Switch2 was added to the network.
Which three issues on Switch2 could be the cause？（）
A.Switch2 is configured for only VLAN1
B.Switch2 is a VTP server in a different domain
C.Switch2 is a VTP server in the Company domain
D.Switch2 is not a VTP domain.
E.Switch2 has a lower VTP configuration revision number than the current VTP revision
F.Switch2 has a higher VTP configuration revision number than the current VTP revision
A.Physical management of the switch
B.Logical management of the switch
C.In-band management of the switch
D.Out-of-band management of the switch
A.Reload the active VLAN configuration
B.Clear the affected port and bring it up again
C.Explicitly set the trunk for the VLAN to be on
D.Remove all the VLANs set
A.The link is using IEEE 802.1Q protocol
B.The link is using IEEE 802.1E protocol
C.Spanning tree is disabled
D.Not enough information to determine
E.The native VLAN information is identical at each end of the link
F.The native VLAN information is different at each end of the link
A.IEEE 802.1Q
B.IEEE 802.10
C.Misconfigured NIC
D.User configuration
E.All of the above
A.SW13 has a higher VTP configuration revision than the current VTP revision
B.SW13 is configured as a VTP server with a different domain name
C.SW13 is configured as a VTP server with the domain name R1
D.SW13 has a lower VTP configuration revision than the current VTP revision
E.SW13 is not configured to participate in VTP
F.SW13 is configured with only VLAN1
On the basis of the following exhibit， can you tell me why VLAN updates from switch CK-P2S1 arenot applied to switch CK-P1S1？（）
A.The MD5 digests do not match
B.Switch CK-P1S1 is in transparent mode
C.The passwords do not match
D.The VTP domains are different
A.In a 6to4 tunnel， the first two bytes of the IPv6 address will be 0x2002 and the next four byteswill be the hexadecimal equivalent of the IPv4 address
B.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the2002：1315：4463：1：：/64 IPv6 address
C.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the 2002：c0a8：6301：：/48IPv6 address
D.In a 6to4 tunnel， the first two bytes of the IPv6 address will be locally derived and the next twobytes will be the hexadecimal equivalent of the IPv4 address
E.In a 6to4 tunnel， the IPv4 address 192.168.99.1 would be converted to the 2002：c0a8：6301：：/16IPv6 address
最新試題
Match the xDSL type on the above to the most appropriate implementation on the below.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Which statement about PPPoA configuration is correct？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
Drag and drop each management protocol on the above to the correct category on the below.
In computer security， AAA stands for authentication， authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）