A.independent of SSO
B.NSF combined with SSO enables supervisor engine load balancing
C.supported by RIPv2， OSPF， IS-IS， and EIGRP
D.supports IPv4 and IPv6 multicast
E.prevents route flapping
F.dependent on FIB tables
您可能感興趣的試卷
你可能感興趣的試題
A.Static IP routes are maintained across a switchover because they are configured from entries inthe configuration file
B.Information about dynamic routing states， maintained on the active supervisor engine， issynchronized to the redundant supervisor engine and is transferred during the switchover
C.Information about dynamic routing states， maintained on the active supervisor engine， is notsynchronized to the redundant supervisor engine and is lost on switchover
D.The Forwarding Information Base （FIB） tables are cleared on a switchover. As a result， routedtraffic is interrupted until route tables reconverge
E.Static IP routes are cleared across a switchover and recreated from entries in the configurationfile on the redundant supervisor engine
F.The Forwarding Information Base （FIB） tables are maintained during the switchover. As aresult， routed traffic continues without any interruption when the failover occurs
A.An SVI is normally created for the default VLAN （VLAN1） to permit remote switchadministration
B.Multiple SVIs can be associated with a VLAN
C.SVI is another name for a routed port
D.An SVI is created by entering the no switchport command in interface configuration mode
E.An SVI provides a default gateway for a VLAN
A.private VLANs
B.port security
C.BPDU guard
D.dynamic ARP inspection
E.DHCP snooping
A.Router ACLs can be applied to the input and output directions of a VLAN interface
B.Bridged ACLs can be applied to the input and output directions of a VLAN interface
C.Only router ACLs can be applied to a VLAN interface
D.VLAN maps and router ACLs can be used in combination
E.VLAN maps can be applied to a VLAN interfac
A.Trunk
B.Isolated
C.Primary
D.Community
E.Promiscuous
F.None of the other alternatives apply
Refer to the exhibit. The user who is connected to interface FastEthernet 0/1 is on VLAN 10 andcannot access network resources. On the basis of the information in the exhibit， which commandsequence would correct the problem？（）
A.SW1（config）# interface fastethernet 0/1 SW1（config-if）# no shut
B.SW1（config）# interface fastethernet 0/1 SW1（config-if）# switchport mode access SW1（config-if）# switchport access vlan 10
C.SW1（config）# vlan 10 SW1（config-vlan）# state active
D.SW1（config）# interface fastethernet 0/1 SW1（config-if）# switchport mode access
E.SW1（config）# vlan 10 SW1（config-vlan）# no shut
You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function
normally， and the new workstation obtains an address when manually forced to renew its address.
What should be configured on the switch to allow the workstation to obtain an IP address at boot？（）
A.UplinkFast on the switch port connected to the server
B.BackboneFast on the switch port connected to the server
C.PortFast on the switch port connected to the workstation
D.trunking on the switch
A.Ports in VLAN 5
B.Utilization
C.VLAN information on port 0/5
D.Filters
E.MTU and type
Refer to the exhibit. On the basis of the output generated by the show commands， which twostatements are true？（）
A.All interfaces on the switch have been configured as access ports
B.Because it has not been assigned to any VLAN， interface gigabitethernet 0/1 does not appearin the show vlan output
C.Because it is configured as a trunk interface， interface gigabitethernet 0/1 does not appear inthe show vlan output
D.There are no native VLANs configured on the trunk
E.VLAN 1 will not be encapsulated with an 802.1q header
F.VLAN 2 will not be encapsulated with an 802.1q header
Refer to the exhibit. Based upon the output of show vlan on switch CAT2， what can we concludeabout interfaces Fa0/13 and Fa0/14？（）
A.that interfaces Fa0/13 and Fa0/14 are in VLAN 1
B.that interfaces Fa0/13 and Fa0/14 are down
C.that interfaces Fa0/13 and Fa0/14 are trunk interfaces
D.that interfaces Fa0/13 and Fa0/14have a domain mismatch with another switch
E.that interfaces Fa0/13 and Fa0/14have a duplex mismatch with another switch
最新試題
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDK click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDK you can return to yourquestions by clicking on the Questions button to the left.Which IPSec rule is used for the Olympia branch and what does it define？（）
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
Which statement about PPPoA configuration is correct？（）
Refer to the exhibit. Which two statements about the AAA configuration are true？（）
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）