多項選擇題Which two are NOT characteristics of the OSPF routing protocol?()

A. It confines network instability to a single area of network.
B. It increases the routing overhead of the network
C. It supports VLSM
D. It routes between Autonomous Systems.
E. It allows extensive control of routing updates


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題What are the characteristic of link state routing protocols?()

A. The exchange of advertisement is triggered by a change in the network.
B. All routers exchange routing tables with each other iIn a multipoint network.
C. Packets are routed based upon the shortest path to the destination.
D. Paths are chosen depending on the cost efficiency factor.
E. Every router in an OSPF area is capable of representing the entire network topology.
F. Only the designated router in an OSPF area can represent the entire network topology.

3.多項選擇題The statements below compare and contrast link state and distance vector routing protocols. Which of these are true?()

A. Distance vector protocols send the entire routing table to directly connected neighbors.
B. Distance vector protocols are responsible for sending updates to all networks listed in the routing table.
C. Link state protocols are responsible for sending the entire routing table to the whole network.
D. Link state protocols send updates regarding their own links status to all other routers on the network.

4.單項選擇題On the assumption that every OSPF router in a particular area is configured with there is no loopback interface set?()

A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.

5.單項選擇題Under which circumstance, ie network type, would an OSPF router establish a neighbor adjacency, even though the DR/BDR election process was not performed?()

A. Point-to-point
B. Broadcast multicast
C. Nonbroadcast multicast
D. Backbone area 0
E. Virtual Link

8.多項選擇題In EIGRP, what kind of route information is stored in the RAM of the router and maintained by way of hello packets and update packets?()

A. Neighbor Table
B. SRF Table
C. RTP Table
D. Topology Table
E. Query Table
F. Dual Table

9.單項選擇題Which one of the following statements best explains the split horizon rule?()

A. Only routers can split boundaries (horizons) between networks in separate AS numbers.
B. Each AS must keep routing tables converged to prevent dead routes from being advertised across boundaries.
C. Once a route is received on an interface, advertise that route as unreachable back out the same interface.
D. Information about a route should never be sent back in the direction from which the original update came.


最新試題

TestKing.com has allocated the IP add 199.144.27.0 is its network, to provide flexibility for the LAN design, a subnet mask of 255.255.255.240 has been chosen. Which of the following address can be assigned to LAN on the resulting subnets.()

題型:多項選擇題

An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? ()

題型:多項選擇題

Which characteristics are representative of a link-state routing protocol?()

題型:多項選擇題

What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?()

題型:單項選擇題

Which of the following correctly describe steps in the OSI data encapsulation process?()

題型:多項選擇題

What is a global command?()

題型:單項選擇題

The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?()

題型:單項選擇題

Which command is used to display the placement and direction of an IP access control list on a router?()

題型:單項選擇題

You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?()

題型:多項選擇題

What does a configuration Register Setting of 0x2105 indicate to the Router? ()

題型:單項選擇題