單項選擇題You work as a technician at TestKing. You are configuring a Cisco router. You want to configure the IP address on an interface.Which command should you use?()

A. router(config-if)#ip address 142.8.2.1 subnet mask 255.255.252.0
B. router(config-if)#142.8.2.1 0.0.3.255
C. router(config-if)#ip address 142.8.2.1 255.255.252.0
D. router(config-if)#142.8.2.1 subnet mask 255.255.252.0
E. router(config-if)#ip address 142.8.2.1 0.0.3.255
F. router(config-if)#ip address 142.8.2.1 subnet mask /22


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題You have been asked to configure a default route. Which of the IOS commands mentioned below will accomplish this task?()

A. LTD(config)# ip route 0.0.0.0 0.0.0.0 192.168.15.36
B. LTD(config)# ip route 0.0.0.0 192.168.15.36 255.255.255.255
C. LTD# ip default-network 0.0.0.0 192.168.15.36 255.255.255.255
D. LTD(config)# ip route 0.0.0.0 0.0.0.0 E0
E. LTD(config)# ip route 0.0.0.0 255.255.255.255 S0
F. LTD(config-router)# ip route 255.255.255.255 0.0.0.0 192.168.15.36

2.單項選擇題Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?()

A. Router(config)# ip default-route 0.0.0.0 255.255.255.255 s0
B. Router(config)# ip route 0.0.0.0 255.255.255.255 s0
C. Router(config)# ip default-route 0.0.0.0 0.0.0.0 s0
D. Router(config)# ip route 0.0.0.0 0.0.0.0 s0
E. Router(config)# ip route any any e0

3.多項選擇題Which of the commands below can you use to configure a default route?()

A. TK1(config)# ip route 0.0.0.0 0.0.0.0 E0
B. TK1(config)# ip route 0.0.0.0 255.255.255.255 S0
C. TK1(config-interface)# ip route 255.255.255.255 0.0.0.0 192.168.1.21
D. TK1(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.21
E. TK1(config)# ip route 0.0.0.0 192.168.1.21 255.255.255.255
F. TK1# ip default-network 0.0.0.0 192.168.1.21 255.255.255.255

4.多項選擇題The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?()

A. The default administrative distance is used.
B. The command is used to establish a static route.
C. The command is used to configure the router interfaces.
D. The command is used to establish a stub network.
E. The subnet mask for the source address is 255.255.255.0

5.單項選擇題In any NAT (network address translation) configuration, what is the Inside Global IP address?()

A. The summarized address for all internal subnetted addresses.
B. A private IP address assigned to a host on the inside network.
C. A registered address that represents an inside host to an outside network.
D. A unique IP address used on an internal network
E. Non of the above

6.單項選擇題

You are a systems administrator and you are about to assign static IP addresses to various servers on your network. For the network 192.168.20.24/29 the router is assigned to the first usable host address, while the last usable host address goes to your Sales server.
Which one of the following commands would you enter into the IP properties box of the sales server?()

A. IP address: 192.168.20.14 Subnet Mask: 255.255.255.248 Default Gateway:192.168.20.9
B. IP address: 192.168.20.254 Subnet Mask: 255.255.255.0 Default Gateway:192.168.20.1
C. IP address: 192.168.20.30 Subnet Mask 255.255.255.248 Default Gateway:192.168.20.25
D. IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:192.168.20.17
E. IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:192.168.20.25

7.多項選擇題The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?()

A. The command is used to establish a static route.
B. The default administrative distance is used.
C. The command is used to configure the default route.
D. The subnet mask for the source address is 255.255.255.0
E. The command is used to establish a stub network

8.多項選擇題Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?()

A. TestKingRouter(config)# router ospf 0
B. TestKingRouter(config)# router ospf 1
C. TestKingRouter(config)# router ospf area 0
D. TestKingRouter(config)# network 192.168.16.0 0.0.0.255 0
E. TestKingRouter(config)# network 192.168.16.0 0.0.0.255 area 0
F. TestKingRouter(config)# network 192.168.16.0 255.255.255.0 area 0

9.多項選擇題On what kinds of networks does OSPF elect a backup designated router?()

A. Point-to-point
B. Point to multipoint
C. Broadcast
D. Non-broadcast multi-access

10.多項選擇題Which of the following are true statements regarding the characteristics of OSPF areas? Select all that apply.()

A. All OSPF networks require the use of multiple areas
B. Multiple OSPF areas must connect to area 0
C. Single area OSPF networks must be configured in area 1
D. Areas can be assigned any number from 0 to 63535
E. Area 0 is called the backbone area
F. Each OSPF area need to be configured with a loopback interface

最新試題

All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?()

題型:單項選擇題

The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? ()

題型:單項選擇題

Which of the following host addresses are member of networks that can be routed across the public Internet? ()

題型:多項選擇題

A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?()

題型:單項選擇題

Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? ()

題型:單項選擇題

Which of the following if addresses can be assigned to host devices?()

題型:多項選擇題

How many usable sub network and usable hosts per subnet result in the network address 201.105.13.0 is sub netted with a mask of /26? ()

題型:單項選擇題

Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?()

題型:多項選擇題

New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()

題型:單項選擇題

Which of the following correctly describe steps in the OSI data encapsulation process?()

題型:多項選擇題