Study the information and the relevant configuration file below for the Testking Branch router
What additional command must be executed on the Branch router before interesting traffic will initiate an ISDN call?（）
A. (config-if)# dialer-group 1
B. (config-if)# dialer-list 1
C. (config-if)# dialer map 1
D. (config-if)# dialer-route 1
您可能感興趣的試卷
你可能感興趣的試題
The following access list below was applied outbound on the E0 interface connected to the 192.169.1.8/29 LAN:
How will the above access lists affect traffic?（）
A. FTP traffic from 192.169.1.22 will be denied.
B. No traffic, except for FTP traffic will be allowed to exit E0.
C. FTP traffic from 192.169.1.9 to any host will be denied.
D. All traffic exiting E0 will be denied.
E. All FTP traffic to network 192.169.1.9/29 will be denied.
A.SMTP
B.DNS
C.FTP
D.Telnet
E.HTTP
F.POP3
A. Application of up to three access lists per protocol to a single interface.
B. No more than two access lists per interface.
C. One access list may be configured per direction for each Layer 3 protocol configured on an interface.
D. The maximum number allowed varies due to RAM availability in the router.
E. An infinite number of access lists that can be applied to an interface, from most specific to most general.
F. Cisco IOS allows only one access list to an interface.
You're the systems administrator at Testing, and you create the following access control lists.
You then enter the command "ip access-group 101 in" to apply access control list 101 to router TK1s e0 interface.Which of the following Telnet sessions will be blocked as a result of your access lists?（）
A. Telnet sessions from host A to host 5.1.1.10
B. Telnet sessions from host A to host 5.1.3.10
C. Telnet sessions from host B to host 5.1.2.10
D. Telnet sessions from host B to host 5.1.3.8
E. Telnet sessions from host C to host 5.1.3.10
F. Telnet sessions from host F to host 5.1.1.10
A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out
A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.
A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash
A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST.
最新試題
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）
What does a configuration Register Setting of 0x2105 indicate to the Router? （）
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?（）
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?（）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
Which of the following describe router functions?（）