You're the systems administrator at Testing, and you create the following access control lists.
You then enter the command "ip access-group 101 in" to apply access control list 101 to router TK1s e0 interface.Which of the following Telnet sessions will be blocked as a result of your access lists?（）
A. Telnet sessions from host A to host 5.1.1.10
B. Telnet sessions from host A to host 5.1.3.10
C. Telnet sessions from host B to host 5.1.2.10
D. Telnet sessions from host B to host 5.1.3.8
E. Telnet sessions from host C to host 5.1.3.10
F. Telnet sessions from host F to host 5.1.1.10
您可能感興趣的試卷
你可能感興趣的試題
A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out
A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.
A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash
A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST.
You are unable to connect to the TESTKING1 router. Which of the following command sequences will correct this problem?（）
A.
B.
C.
D.
E.
F.
You want the text "Unauthorized access prohibited!" to be displayed before the login prompt every time someone tries to initiate a Telnet session to a router, as shown in the example below:
Which command can be used to configure this message?（）
A. login banner x Unauthorized access prohibited! X
B. banner exec y Unauthorized access prohibited! Y
C. banner motd x Unauthorized access prohibited! X
D. vtv motd "Unauthorized access prohibited!"
The TestKingA router is configured as shown below:
TestKingA(config)# interface loopback 0
TestKingA(config-if)# ip address 192.168.16.24 255.255.255.255
As a result of this change, which of the statements below are true?（）
A. It creates a virtual, software only, interface.
B. It provides a way to test the convergence of OSPF routing updates.
C. The mask of 255.255.255.255 is called a host mask.
D. It uses a wildcard mask of 255.255.255.255.
E. It ensures that an interface is always active for OSPF processes.
F. Loopback interfaces must be numbered 0.
A CCNA candidate is working on a 2600 Cisco router. The person needs to verify that the configuration register is set to boot the router IOS from flash memory and use the commands saved in the startup-configuration file.
Which command will display this information, and what is the configuration register value that should be displayed?（）
A. show startup-config and 0x2142
B. show version and 0x2102
C. show flash and 0x2102
D. show version and 0x2142
E. show running-config and 0x2142
F. show flash and 0x2142
最新試題
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
Which connections allow the use of full-duplex Ethernet?（）
Which of the following statements regarding routed and routing protocols are true?（）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?（）
Which of the following correctly describe steps in the OSI data encapsulation process?（）
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? （）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）
Which characteristics are representative of a link-state routing protocol?（）