單項選擇題You are logged into a router and with to view the layer 3 information about your neighboring Cisco routers. What IOS command gives layer 3 information for of the directly connected router interfaces?()

A. show ip links
B. show cdp neighbor
C. show cdp neighbor detail
D. show ip clients
E. show ip route
F. None of the above


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題In the context of configuring dial-on-demand routing using ISDN, what is the purpose of the dialer-list command?()

A. to identify valid numbers for incoming calls
B. to define the type of ISDN switch at the central office
C. to specify the list of outgoing phone numbers used by the router
D. to associate a dial configuration with a physical interface
E. to define interesting traffic that will enable the link

2.單項選擇題A network administrator needs to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface for this connection?()

A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above

3.多項選擇題Which statements are true about EIGRP successor routes?()

A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.

4.單項選擇題You are troubleshooting a frame relay connection and wish to view the LMI traffic stats. Which command should you issue?()

A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.

7.單項選擇題You have just obtained a modular Cisco router with 2 serial connections and a BRI/U interface. What other physical piece of hardware is required in order to establish an ISDN connection?()

A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.

10.單項選擇題Which of the following Frame-Relay encapsulation commands would you use, if you had to connect your Cisco router to a non-Cisco router?()

A. TestKRouter(config-if)# Encapsulation frame-relay dot1q
B. TestKRouter(config-if)# Encapsulation frame-relay aal5snap
C. TestKRouter(config-if)# Encapsulation frame-relay ietf
D. TestKRouter(config-if)# Encapsulation frame-relay isl
E. None of the above

最新試題

A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?()

題型:多項選擇題

Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. ()

題型:多項選擇題

Which of the following contribute to congestion on an Ethernet network?()

題型:多項選擇題

New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()

題型:單項選擇題

What feature of a networks switch allows an administrative to create separate broadcast domains?()

題型:單項選擇題

Which of the following correctly describe steps in the OSI data encapsulation process?()

題型:多項選擇題

A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()

題型:單項選擇題

The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?()

題型:單項選擇題

TestKing.com has allocated the IP add 199.144.27.0 is its network, to provide flexibility for the LAN design, a subnet mask of 255.255.255.240 has been chosen. Which of the following address can be assigned to LAN on the resulting subnets.()

題型:多項選擇題

Which command is used to display the placement and direction of an IP access control list on a router?()

題型:單項選擇題