A.20
B.5
C.15
D.10
您可能感興趣的試卷
你可能感興趣的試題
A.chooses the least congested channel
B.uses the configured channel
C.sets all access points to the same channel
D.steps through each of the allowed channels
A.eap-fast master server
B.allow automatic pac provisioning
C.client initial message
D.authority id info
A.two
B.three
C.four
D.one
On a cisco aironet 1230 series autonomous access point， the status led is solid red， and the ethernet and radio leds are both off.
What does this indicate？（）
A.a firmware upgrade is in progress.
B.the internal radio has failed.
C.an access point buffer overflow is occurring.
D.the access point is booting.
A.8
B.32
C.4
D.16
On a cisco aironet 1130 series autonomous access point， the status indicator is blinking dark blue.
What does this indicate？（）
A.the access point is booting.
B.a firmware upgrade is in progress.
C.the internal radio has failed.
D.an access point buffer overflow is occurring.
Scalability： with the cisco wireless location appliance， 2500 devices including wireless clients or wi-fi tags can be tracked simultaneously， helping ensure that location services can be applied to an entire enterprise environment.
Which of the following functions on the wireless lan controller is used to determine whether or not a rogue access point is connected to the same layer 2 network？（）
A.rogue detector
B.rogue containment
C.rldp
D.ridp
A.1000
B.2000
C.2500
D.1500
You are troubleshooting a problem with a cisco 7920 wireless ip phone on a standalone wlan. the phone rings but， when you Answer ，the call is dropped.
What may have caused this problem？（）
A.publicly secure packet forwarding is enabled.
B.the minimum data rate is not set to 11 mbps.
C.an address resolution protocol is enabled.
D.the access point is set to the least congested channel.
A cisco wcs version 4.0 has been installed on a server with a dual pentium 3.0 ghz processor，4 gb ram，and an 80 gb hard drive. a location appliance has been incorporated into the network and is being monitored by the cisco wcs. there are 3000 devices to be tracked but not all of them are being tracked on the cisco wcs.
What can be done to correct the problem？（）
A.add a new location appliance.
B.add a new cisco wcs server dedicated to the location appliance.
C.add 4 gb of ram to the cisco wcs.
D.add a 120 gb hard drive to the cisco wcs.
最新試題
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）