單項選擇題Which protocol is an open standard protocol frame work that is commonly used in VPNs,to provid secureend-to-end communication?()

A.L2TP
B.IPsec
C.PPTP
D.RSA


您可能感興趣的試卷

你可能感興趣的試題

3.單項選擇題

根據下圖中展示的show  running-config命令的結果。網絡管理員該如何做才能允許工作站連接到FastEthernet0/0接口去獲得一個IP地址?()

A.在接口FastE thernet0/0應用access-group14
B.在access-list14中添加access-list 14 permit any any
C.配置FastE therent0/0接口的IP地址為10.90.201.1
D.為接口FastE thernet0/0添加一個接口描述

4.多項選擇題What three pieces of information can be used in an extended access list to filter traffic (Choose three.)()。

A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address

5.單項選擇題Acknowldgement, Sequencing, and Flow control are characteristics of which OSI layer?()

A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7

6.單項選擇題The administrator is unable to establish connectivity between two Cisco routers. Upon reviewing the command output of both routers, what is the most likely caust of the problem?()

A.Authentication needs to be changed to PAP for both routers.
B.Serial IP addresses of routers are not on the same subnet.
C.Username/password is incorrectly configured.
D.Router names are incorrectly configured.

7.多項選擇題

Exhibit: Which of the following are true regarding the command output shown in the display (Choose two.)()。

A.There are at least two routers participating in the RIP process.
B.A ping to 192.168.168.2 will be successful.
C.A ping to 10.0.15.2 will be successful.
D.RtrA has three interfaces participating in the RIP process.

10.多項選擇題Which can be done to secure the virtual terminal interfaces on a router?()

A.Administratively shut down the interfaces.
B.Physically secure the interfaces.
C.Configure a virtual terminal password and login process.
D.Enter an access list and apply it to the terminal interfaces using the access-class command.
E.Create an access list and apply it to the terminal interfaces using the access-groupc ommand.

最新試題

何時必須使用clock rate 命令配置路由器串行接口?()

題型:單項選擇題

請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()

題型:單項選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:單項選擇題

要將數據包發送到遠程網絡,應使用哪種設備?()

題型:單項選擇題

請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()

題型:單項選擇題

以下哪兩種介質可提供高達1Gb/s 的帶寬?()

題型:多項選擇題

請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()

題型:單項選擇題

在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()

題型:單項選擇題

下列哪些是私有IP 地址的地址范圍?()

題型:多項選擇題

PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()

題型:單項選擇題