A.one
B.two
C.three
D.four
E.six
F.fourteen
您可能感興趣的試卷
你可能感興趣的試題
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?()
A.The Gallant router has the wrong LM Itype configured
B.Inverse ARP is providing the wrong PVC information to the Gallant router
C.The S3 interface ofthe Steele router has been configured with the frame-relay encapsulation ietf command
D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct
E.The IP address on the serial interface of the Attalla router is configured incorrectly
A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A.172.25.78.243
B.172.25.98.16
C.172.25.72.0
D.172.25.94.255
E.172.25.96.17
F.172.25.100.16
A.A variance was configured for EIGRP autonomous system 109.
B.The EIGRP topology table displays all routes to a destination.
C.The EIGRP topology table shows only backup routes to a destination.
D.Multiple floating static routes were configured to network 192.168.81.0 via interface Serial0.
A.transparent
B.auto
C.on
D.desirable
E.client
F.forwarding
A.Make sure that the server can be reached across the network.
B.Check that authentication for TFTP access to the server is set.
C.Assure that the network server has adequate space for the IOS image.
D.Verify file naming and path requirements.
E.Make sure that the server can store binary files.
F.Adjust the TCP window size to speed up the transfer.
A.Replace the straight-through cable with a crossover cable
B.Change the subnet mask of the hosts to /25
C.Change the subnet mask of the hosts to /26
D.Change the address of Workstation A to 192.0.2.15
E.Change the address of Workstation B to 192.0.2.111
A.Switch1(config-if)# switchport port-security maximum 1
B.Switch1(config)# mac-address-table secure
C.Switch1(config)# access-list 10 permit ip host
D.Switch1(config-if)# switchport port-security violation shutdown
E.Switch1(config-if)# ip access-group 10
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
最新試題
OSI 模型的哪兩項功能在第2層實現?()
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet??梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
請參見圖示。公司路由器由于故障被更換。更換路由器之后,Education 辦公室內的主機C 和D 能夠相互ping 通,但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
何時必須使用clock rate 命令配置路由器串行接口?()
請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()
請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()