問答題What is the PMTUD for IPv6 network?

您可能感興趣的試卷

你可能感興趣的試題

2.多項(xiàng)選擇題

Refer to the exhibit. Two ISPs have decided to use MSDP and configured routers X and Y (both are PIM RPs) as MSDP peers. In the domain of ISP B, PC A has sent an IGMP membership report for the group 224.1.1.1 and PC B has sent an IGMP membership report for the group 224.5.5.5. Assuming that the MSDP peering relationship between routers X and Y is functional, and given the partial configuration output shown from router X, which two of these statements are true?() 

A.Router X will contain an entry for 224.1.1.1 in its SA cache and will also have an installed (S,G) entry for this in its mroute table.
B.Router X will not contain an entry for 224.1.1.1 in its SA cache but will have an installed (*,G) entry for this in its mroute table.
C.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed (S,G) entry for this in its mroute table.
D.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed (*,G) entry for this in its mroute table.
E.Router X will have no entries for 224.5.5.5 in neither its SA cache nor in its mroute table.
F.Router X will have no entries for 224.1.1.1 in neither its SA cache nor in its mroute table.

7.單項(xiàng)選擇題Which statement best describes OSPF external LSAs (type 5)?()

A.OSPF external LSAs are automatically flooded into all OSPF areas, unlike type 7 LSAs, which require that redistribution be configured.
B.External LSAs (type 5) are automatically changed to type 1 LSAs at ASBRs.
C.Type 5 LSAs are route summaries describing routes to networks outside the OSPF Autonomous System.
D.External network LSAs (type 5) redistributed from other routing protocols into OSPF are not permitted to flood into a stub area.

8.單項(xiàng)選擇題This question is about the formation of OSPF adjacency. An OSPF adjacency will not form correctly across a point-to-point link in the same area. Which would most likely cause this problem?()

A.Each interface has a different OSPF cost.
B.Each interface is configured with secondary addresses as well as primary addresses.
C.Each interface has a different MTU size.
D.Each interface is configured with theip unnumbered loopback 0 command.